Response of grain sorghum to low rates of glufosinate and nicosulfuron

摘要

Previous research has shown that glufosinate and nicosulfuron at low rates can cause yield loss to grain sorghum. However, research has not been conducted to pinpoint the growth stage at which these herbicides are most injurious to grain sorghum. Therefore, field tests were conducted in 2016 and 2017 to determine the most sensitive growth stage for grain sorghum exposure to both glufosinate and nicosulfuron. Field test were designed with factor A being the herbicide applied (glufosinate or nicosulfuron). Factor B consisted of timing of herbicide application including V3, V8, flagleaf, heading, and soft dough stages. Factor C was glufosinate or nicosulfuron rate where a proportional rate of 656 g ai ha(-1) of glufosinate and 35 g ai ha(-1) of nicosulfuron was applied at 1/10x, 1/50x, and 1/250x. Visible injury, crop canopy heights (cm), and yield were reported as a percent of the nontreated. At the V3 growth stage visible injury of 32 from the 1/10x rate of glufosinate and 51 from the 1/10x rate of nicosulfuron was observed. This injury was reduced by 4 wk after application (WAA) and no yield loss occurred. Nicosulfuron was more injurious than glufosinate at a 1/10x and 1/50x rate when applied at the V8 and flagleaf growth stages resulting in death of the shoot, reduced heading, and yield. Yield losses from the 1/10x rate of nicosulfuron were observed from V8 through early heading and ranged from 41 to 96. Yield losses from the 1/50x rate of nicosulfuron were 14 to 16 at the flagleaf and V8 growth stages respectively. The 1/10x rate of glufosinate caused 36 visible injury 2 WAA when applied at the flagleaf stage, which resulted in a 16 yield reduction. By 4 WAA visible injury from either herbicide at less than the 1/10x rate was not greater than 4. Results indicate that injury can occur, but yield losses are more probable from low rates of nicosulfuron at V8 and flagleaf growth stages.