...
【24h】

Biomechanical evaluation of different suture anchors for the stabilization of anterior labrum lesions.

机译:生物力学评价不同的缝合稳定的锚前唇状结构病变。

获取原文
获取原文并翻译 | 示例
           

摘要

PURPOSE: The aim of the study was to investigate the biomechanical performance of different devices for anterior shoulder reconstruction in a clinically relevant human cadaver shoulder model. TYPE OF STUDY: Biomechanical cadaveric study. METHODS: The soft tissue, except for the joint capsule, was dissected from 28 fresh-frozen human shoulder specimens. A Bankart lesion was created and repaired with 3 suture anchors. The devices tested were the 2.4-mm Fastak (Arthrex, Karlsfeld, Germany) with either Ethibond (Ethicon, Westwood, MA) no. 2 or 3, the 2.8-mm Fastak with Ethibond no. 2, the Panalok (Mitek, Norwood, MA) with Ethibond no. 2 with a modified setting technique, and the 8-mm Suretac (Acufex Microsurgical, Mansfield, MA). The specimens were anteriorly dislocated in 60 degrees glenohumeral abduction and 90 degrees external rotation. Load was measured continuously and failures were noted. The experimental groups were compared with each other and with a control group with intact shoulders. RESULTS: Bankart repair with 2.4-mm Fastaks and Ethibond no. 2 and 3 failed at a mean load of 342.0 N and 692.2 N, respectively, predominantly by suture rupture at the eyelet of the anchor. Shoulder reconstruction with 2.8-mm Fastaks failed at an average load of 722.8 N, mostly by suture rupture at the knot. The difference to the 2.4-mm Fastak with Ethibond no. 2 was significant (P < .05). The mean load to failure was 983.8 N in the Panalok group, and the most frequent failure mode was suture rupture at the knot. Bankart repair with Suretac failed at an average load of 468.4 N, typically by capsular damage at the repair site. Capsular injuries in the control group occurred at a mean load of 958.2 N. Anterior shoulder reconstruction with 2.4-mm Fastak with Ethibond no. 2 and with Suretac were statistically significantly inferior to the control group (P < .05). CONCLUSIONS: All tested devices allow stable anterior shoulder reconstruction, but we recommend the Panalok and the 2.8-mm Fastak because they provided greater stability than either the 2.4-mm Fastak or the Suretac in our experiments. Suretac can possibly cause additional capsular damage in redislocations after Bankart repair. CLINICAL RELEVANCE: This cadaveric study gives an insight into the biomechanical performance of a Bankart repair with different devices directly postoperative and shows possible failure modes and additional injuries in case of early traumatic redislocation.
机译:目的:这项研究的目的是调查不同的生物力学性能设备为前肩重建临床相关的人类尸体肩模型。类型的研究:生物力学研究尸体。方法:软组织,除了关节胶囊,从28人用来进行解剖肩部标本。和修复3缝合锚。测试是2.4毫米Fastak (ArthrexEthibond Karlsfeld,德国)(Ethicon,韦斯特伍德,MA)没有。诺伍德,MA) Ethibond没有。设置技术,和8毫米Suretac (Acufex显微外科,曼斯菲尔德,MA)。在前面在60度盂肱脱臼绑架和外部旋转90度。连续测量和失败吗指出。彼此,与对照组完好无损的肩膀。Fastaks Ethibond没有。负载分别为342.0和692.2 N,主要由冲孔的缝合断裂锚。在平均负载为722.8 N, Fastaks失败主要由缝合断裂结。影响2.4毫米Fastak Ethibond没有。2显著(P < . 05)。失败是983.8 N Panalok组,最常见的失效模式是缝合断裂结。平均负载为468.4 N,通常由荚膜损伤的修复。对照组发生在平均负载958.2 n前肩重建2.4毫米Fastak Ethibond没有。Suretac在统计学上显著低对照组(P < . 05)。测试设备允许稳定前的肩膀重建,但我们建议Panalok和2.8毫米Fastak是因为他们提供了更大的稳定性比2.4 mm Fastak或Suretac在我们的实验。引起额外的荚膜损伤板卡特修理后复脱位。相关性:这尸体的研究给出了的观点板卡特的生物力学性能直接与不同的设备修理术后并显示可能的失效模式提前和额外伤害的创伤复脱位。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号