首页> 外文期刊>Veterinary Parasitology >Effects of heating laying hen houses between consecutive laying cycles on the survival of the poultry red mite Dermanyssus gallinae
【24h】

Effects of heating laying hen houses between consecutive laying cycles on the survival of the poultry red mite Dermanyssus gallinae

机译:连续铺设在禽红螨Dermanyssus Hallinae的饲养过程中连续铺设循环之间的疗效

获取原文
获取原文并翻译 | 示例
       

摘要

The poultry red mite (PRM) Dermanyssus gallinae, the most common ectoparasite affecting laying hens worldwide, is difficult to control. During the period between consecutive laying cycles, when no hens are present in the layer house, the PRM population can be reduced drastically. Heating a layer house to temperatures above 45 degrees C for several days in order to kill PRM has been applied in Europe. The effect of such a heat treatment on the survival of PRM adults, nymphs and eggs, however, is largely unknown. To determine that effect, an experiment was executed in four layer houses. Nylon bags with ten PRM adults, nymphs or eggs were placed at five different locations, being a) inside the nest boxes, b) between two wooden boards, to simulate refugia, c) near an air inlet, d) on the floor, under approximately 1 cm of manure and e) on the floor without manure. Mite survival was measured in 6 replicates of each of these locations in each of four layer houses. After heating up the layer house, in this case with a wood pellet burning heater, the temperature of the layer house was maintained at >= 45 degrees C for at least 48 h. Thereafter, the bags were collected and the mites were assessed as being dead or alive. The eggs were assessed for hatchability. Despite a maximum temperature of only 44 degrees C being reached at one location, near an air inlet, all stages of PRM were dead after the heat treatment. It can be concluded that a heat treatment of layer houses between consecutive laying cycles appears to be an effective method to control PRM.
机译:家禽红螨(PRM)是影响全世界蛋鸡的最常见体外寄生虫,难以控制。在连续产蛋周期之间,当蛋鸡房中没有母鸡时,PRM的数量会急剧减少。在欧洲,为了杀死PRM,已经将蛋鸡房加热到45摄氏度以上几天。然而,这种热处理对PRM成虫、若虫和卵存活的影响在很大程度上尚不清楚。为了确定这种影响,在四层房屋中进行了一项实验。尼龙袋和10个PRM成虫、若虫或卵被放置在五个不同的位置,分别是a)巢盒内,b)两块木板之间,以模拟避难所,c)靠近进气口,d)在地板上,在大约1厘米的粪肥下,e)在没有粪肥的地板上。在四层房屋的每个位置的6个重复中测量了螨的存活率。在用木屑燃烧加热器加热蛋鸡房后,蛋鸡房的温度保持在>=45摄氏度至少48小时。此后,收集袋子,并评估螨虫是否死亡或存活。对卵进行孵化能力评估。尽管在靠近进气口的一个位置,最高温度仅达到44摄氏度,但在热处理后,PRM的所有阶段都已死亡。可以得出结论,在连续铺设周期之间对蛋壳进行热处理似乎是控制PRM的有效方法。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号