首页> 外文期刊>Journal of Physics, D. Applied Physics: A Europhysics Journal >Investigation of the frequency dependent spatio-temporal dynamics and controllability of microdischarges in unipolar pulsed plasma electrolytic oxidation
【24h】

Investigation of the frequency dependent spatio-temporal dynamics and controllability of microdischarges in unipolar pulsed plasma electrolytic oxidation

机译:单极脉冲等离子体电解氧化频率依赖性时空动力学及微探测的可控性研究

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

The unipolar pulsed-plasma electrolytic oxidation (PEO) of aluminum has been replaced by bipolar pulsed methods that use a so-called 'soft-sparking'mode. This method results in an effective reduction of intense microdischarges, which are detrimental to the oxide layer. In a previous publication, we developed an in-situ multivariable microdischarge control scheme using unipolar pulsing. Using this method, it is possible to restrict the mean microdischarge size to well-defined limits, while at the same time influencing the mean microdischarge energy, number density or spectral emission behaviour. This method operates well inside a frequency range of f = 1-20 kHz. Although this method shows highly desirable plasma control properties, the mechanisms defining this frequency-dependent controllability are unclear. The aim of this study is to visualize the spatio-temporal behavior of microdischarges in higher frequency ranges. First, a wavelet transform was performed to estimate the temporal evolution of microdischarge lifetimes. Ceramic coatings were then deposited on aluminum alloy substrates in an aqueous solution using unipolar pulsed galvanostatic PEO. The aluminum samples were coated for 30 min at frequencies of f(1) = 50 Hz, f(2) = 5 kHz f(3) = 100 kHz. High-speed imaging was carried out utilizing four synchronized intensified charge-coupled device (ICCD) cameras, each with a 500 ns exposure time. At f(2) = 5 kHz, the microdischarges were still able to follow the electrical pulses. In this regime, the process can be divided into two stages, an initial charging of the substrate surface without plasma emission and a subsequent slower evolution of microdischarges. Equivalent circuit model descriptions are given for both processes. At f(3) = 100 kHz, microdischarges were not able to follow the pulse frequency, as the lifetimes and risetimes of the microdischarge characteristics were longer than the pulse length. Reignition at the same spatial location, clustering and permanent ignition through pulse periods were observed.
机译:铝的单极脉冲等离子体电解氧化(PEO)已被使用所谓“软火花”模式的双极脉冲方法所取代。这种方法可以有效减少对氧化层有害的强微放电。在之前的出版物中,我们开发了一种使用单极性脉冲的现场多变量微放电控制方案。使用这种方法,可以将平均微放电尺寸限制在明确定义的范围内,同时影响平均微放电能量、数密度或光谱发射行为。该方法在f=1-20 kHz的频率范围内运行良好。虽然这种方法显示出非常理想的等离子体控制特性,但定义这种频率相关可控性的机制尚不清楚。本研究的目的是在更高的频率范围内可视化微放电的时空行为。首先,利用小波变换估计微放电寿命的时间演化。然后使用单极性脉冲恒流PEO在水溶液中在铝合金基体上沉积陶瓷涂层。在频率为f(1)=50 Hz,f(2)=5 kHz,f(3)=100 kHz的条件下,对铝样品进行30分钟的涂覆。利用四台同步增强电荷耦合器件(ICCD)相机进行高速成像,每台相机的曝光时间为500 ns。在f(2)=5 kHz时,微放电仍然能够跟踪电脉冲。在这种情况下,该过程可分为两个阶段,一个是在没有等离子体发射的情况下对衬底表面进行初始充电,另一个是随后缓慢发展的微放电。给出了这两种过程的等效电路模型描述。在f(3)=100 kHz时,微放电不能跟随脉冲频率,因为微放电特性的寿命和上升时间长于脉冲长度。在相同的空间位置观察到重燃、聚集和通过脉冲周期的永久点火。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号