首页> 外文期刊>ACS applied materials & interfaces >Enhanced Current Transport and Injection in Thin-Film Gallium-Nitride Light-Emitting Diodes by Laser-Based Doping
【24h】

Enhanced Current Transport and Injection in Thin-Film Gallium-Nitride Light-Emitting Diodes by Laser-Based Doping

机译:通过激光基掺杂增强薄膜氮化镓发光二极管的电流传输和注入

获取原文
获取原文并翻译 | 示例
           

摘要

This paper reports improvements in the electrical and optical properties of blue-emission gallium nitride (GaN)-based thin-film light-emitting diodes (TFLEDs) after laser-based Si doping (LBSD) of a nitrogen-face n-GaN (denoted as hereafter n-GaN) layer. Experimental results show that the light-output powers of the flat- and rough-surface TFLEDs after LBSD are 52.1 and 11.35% higher than those before LBSD, respectively, at a current of 350 mA, while the corresponding operating voltages are decreased by 0.22 and 0.28 V for the flat- and rough-surface TFLEDs after LBSD, respectively. The reduced operating voltage after LBSD of the top n-GaN layer may result from the remarkably decreased specific contact resistance at the metal-GaN interface and the low series resistance of the TFLED device. The LBSD of n-GaN increases the number of nitrogen vacancies, and Si substitutes for Ga (Si_(Ga)) at the metal-GaN interface to produce highly Si-doped regions in n-GaN, leading to a decrease in the Schottky barrier height and width. As a result, the specific contact resistances are significantly decreased to 1.56 X 10~(-5) and 2.86 X 10~(-5) Ω cm~2 for the flat- and rough-surface samples after LBSD, respectively. On the other hand, the increased light-output power after LBSD can be explained by the uniform current spreading, efficient current injection, and enhanced light scattering resulting from the low contact resistivity, low lateral current resistance, and additional textured surface, respectively. Furthermore, LBSD did not degrade the electrical properties of the TFLEDs owing to low reverse leakage currents. The results indicate that our approach could potentially enable high-efficiency and high-power capabilities for optoelectronic devices.
机译:本文报道了氮面n-GaN的基于激光的Si掺杂(LBSD)之后,基于蓝光发射的氮化镓(GaN)的薄膜发光二极管(TFLED)的电学和光学性能的改进如以下的n-GaN)层。实验结果表明,在电流为350 mA的情况下,LBSD后的平面和粗糙表面TFLED的光输出功率分别比LBSD前的光输出功率高52.1和11.35%,而相应的工作电压分别降低了0.22和1.52。 LBSD之后的平面和粗糙表面TFLED分别为0.28V。在顶部n-GaN层的LBSD之后降低的工作电压可能是由于金属/ n-GaN界面处的比接触电阻显着降低以及TFLED器件的低串联电阻引起的。 n-GaN的LBSD增加了氮空位的数量,并且在金属/ n-GaN界面处用Si代替Ga(Si_(Ga))以在n-GaN中产生高Si掺杂区域,从而导致氮化镓的减少。肖特基势垒的高度和宽度。结果,LBSD后的平坦和粗糙表面样品的比接触电阻显着降低至1.56 X 10〜(-5)和2.86 X 10〜(-5)Ωcm〜2。另一方面,LBSD之后增加的光输出功率可以用均匀的电流散布,有效的电流注入和分别由低接触电阻率,低横向电流电阻和附加纹理化表面导致的增强的光散射来解释。此外,由于低反向泄漏电流,LBSD不会降低TFLED的电性能。结果表明,我们的方法可以潜在地实现光电设备的高效率和高功率功能。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号