首页> 外文期刊>Journal of Materials Science >Supported and unsupported platinum catalysts prepared by a one-step dry deposition method and their oxygen reduction reactivity in acidic media
【24h】

Supported and unsupported platinum catalysts prepared by a one-step dry deposition method and their oxygen reduction reactivity in acidic media

机译:通过一步干法沉积制备的负载型和非负载型铂催化剂及其在酸性介质中的氧还原反应性

获取原文
获取原文并翻译 | 示例
           

摘要

The present study examines the physical and electrochemical properties of platinum particles generated by a combustion method for use in oxygen reduction on the cathode side of a proton exchange fuel cell (PEMFC). This method employs a one-step, open-atmosphere, and dry deposition technique called reactive spray deposition technology (RSDT). The objective of this study is to characterize the intrinsic activity of the platinum produced for incorporation into low-loading cathode electrodes in high performing membrane electrode assemblies (MEA). The process allows for independent real-time control of the carbon, platinum and ionomer ratios in the final electrode. In this research work we examine the oxygen reduction reaction via a rotating disk three electrode set-up to understand the intrinsic activity of the as-sprayed platinum as well as platinum condensed onto a carbon support. The mass and specific activities were measured in a 0.1 M perchloric acid electrolyte under different deposition conditions and loading was verified by atomic emission spectroscopy inductively coupled plasma (AES-ICP). Microscopy results indicate that the platinum particle sizes are 5 nm (σ = 2.8 nm) in diameter while TEM and XRD show that the platinum generated by the process is pure and crystalline without bulk oxides or precursor material present. The initial rotating disk electrode result shows that the RSDT technique is capable of producing catalysts with an oxygen reduction mass activity at 0.9 V of 200 mA/mgPt rotating at 1600 rpm and 30 °C. The electrochemically active surface area approaches 120 m ~2/g for the platinum, carbon, and ionomer samples and the unsupported sample with only platinum has an active area of 92 m ~2/g. The rather larger surface area of the unsupported sample exists when the platinum is deposited as a highly porous nanostructured layer that allows for high penetration of reactant.
机译:本研究研究了通过燃烧方法产生的铂颗粒的物理和电化学性质,该方法用于质子交换燃料电池(PEMFC)阴极侧的氧气还原。此方法采用一种称为反应性喷涂沉积技术(RSDT)的单步开放式大气干燥沉积技术。这项研究的目的是表征为掺入高性能膜电极组件(MEA)中的低负载阴极电极而生产的铂的固有活性。该过程允许对最终电极中的碳,铂和离聚物比率进行独立的实时控制。在这项研究工作中,我们通过旋转圆盘三电极装置检查了氧还原反应,以了解喷涂后的铂以及缩合到碳载体上的铂的固有活性。在不同沉积条件下,在0.1 M高氯酸电解质中测量质量和比活,并通过原子发射光谱电感耦合等离子体(AES-ICP)验证了负载。显微镜结果表明,铂的粒径为5 nm(σ= 2.8 nm),而TEM和XRD显示,该工艺产生的铂是纯净的且结晶的,没有本体氧化物或前体材料存在。最初的转盘电极结果表明,RSDT技术能够生产在0.9 V时氧还原质量活度为200 mA / mgPt且在1600 rpm和30°C下旋转的催化剂。对于铂,碳和离聚物样品,电化学活性表面积接近120 m〜2 / g,仅含铂的无载体样品的活性面积为92 m〜2 / g。当铂沉积为高度多孔的纳米结构层时,存在未负载样品的相当大的表面积,从而允许反应物的高度渗透。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号