...
首页> 外文期刊>Journal of Solution Chemistry >Phase equilibria and volumetric properties of (1-ethyl-3-methylimidazolium ethylsulfate plus alcohol or water) binary systems
【24h】

Phase equilibria and volumetric properties of (1-ethyl-3-methylimidazolium ethylsulfate plus alcohol or water) binary systems

机译:(1-乙基-3-甲基咪唑乙基硫酸盐加乙醇或水)二元体系的相平衡和体积性质

获取原文
获取原文并翻译 | 示例

摘要

Solid-liquid and liquid-liquid phase equilibria in binary mixtures that contain a room-temperature ionic liquid and an alcohol, or water-namely, 1-ethyl-3-methylimidazolium ethylsulfate, [EMIM][EtSO4] with an alcohol (1-octanol, or 1-decanol, or 1-undecanol, or 1-dodecanol) and water have been measured at normal pressure by a dynamic method from 250 to 350 K. By increasing the alkyl chain length of an alcohol, the upper critical solution temperature, UCST, increased (changing from 1-undecanol to 1-dodecanol). Complete miscibility was observed for the systems ([EMIM][EtSO4]+methanol, or ethanol, or 1-propanol, or 1-butanol, 1-pentanol, or 1-hexanol, or 1-heptanol, or 1-octanol, or 1-nonanol, -or 1-decanol and water) at the temperature 298.15 K. Densities and excess molar volumes, V-m(E), have been determined for [EMIM][EtSO4] with either 1-propanol, or 1-butanol, or 1-pentanol, or 1-hexanol, or 1-heptanol, or 1-octanol, or 1-nonanol, or 1-decanol at 298.15 K and ambient pressure. These systems exhibit negative or positive molar excess volumes. Our experimental V-m(E) data were used for the description of H-m(E) for the chosen systems of [EMIM][EtSO4] with the alcohols under study. The simple Prigogine-Flory-Paterson (PFP) model has given slightly worse results than the Flory-Benson-Treszczanowicz (FBT) model. Negative excess molar volumes observed for 1-propanol and 1-butanol are attributed to hydrogen bonding between the short chain alcohols and ionic liquid, and high packing effects. The FBT model overestimates the self-association of the alcohols in the solutions under study and shifts the calculated curves to higher mole fraction of the alcohol. For each system and for chosen number of the Redlich-Kister parameters, A(r), the partial molar volumes, V-1(E) and V-2(E), are presented. The paper includes a basic thermophysical characterization (enthalpy of fusion and temperature of glass phase transition) of the pure ionic liquid obtained via differential scanning calorimetry (DSC) and temperature of decomposition (TG/DTA).
机译:包含室温离子液体和醇(或水,即1-乙基-3-甲基咪唑乙基硫酸乙酯,[EMIM] [EtSO4])与​​醇(1-的水)的二元混合物中的固-液和液-液相平衡辛醇或1-癸醇或1-十一烷醇或1-十二烷醇)和水已通过动态方法在250至350 K的常压下进行了测量。通过增加醇的烷基链长,上限溶液的最高温度,UCST增加(从1-十一烷醇变为1-十二烷醇)。观察到系统完全混溶([EMIM] [EtSO4] +甲醇,或乙醇,或1-丙醇,或1-丁醇,1-戊醇,或1-己醇,或1-庚醇,或1-辛醇,或1-壬醇,-或1-癸醇和水)在298.15 K的温度下。使用1-丙醇或1-丁醇测定[EMIM] [EtSO4]的密度和过量摩尔体积Vm(E),或在298.15 K和环境压力下的1-戊醇或1-己醇或1-庚醇或1-辛醇或1-壬醇或1-癸醇。这些系统表现出负的或正的摩尔过量体积。我们的实验V-m(E)数据用于描述所选[EMIM] [EtSO4]与所研究醇的体系的H-m(E)。简单的Prigogine-Flory-Paterson(PFP)模型给出的结果比Flory-Benson-Treszczanowicz(FBT)模型稍差。 1-丙醇和1-丁醇的负过量摩尔体积归因于短链醇和离子液体之间的氢键键合以及高堆积效应。 FBT模型高估了所研究溶液中醇的自缔合,并将计算得出的曲线移至醇的较高摩尔分数。对于每个系统和Redlich-Kister参数的选定数量A(r),将显示部分摩尔体积V-1(E)和V-2(E)。本文包括通过差示扫描量热法(DSC)和分解温度(TG / DTA)获得的纯离子液体的基本热物理特征(熔融焓和玻璃相转变温度)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号