...
首页> 外文期刊>Journal of Fluid Mechanics >Dense granular flow down an inclined plane: from kinetic theory to granular dynamics
【24h】

Dense granular flow down an inclined plane: from kinetic theory to granular dynamics

机译:沿倾斜平面的密集颗粒流:从动力学理论到颗粒动力学

获取原文
获取原文并翻译 | 示例

摘要

The hydrodynamics of the dense granular flow of rough inelastic particles down an inclined plane is analysed using constitutive relations derived from kinetic theory. The basic equations are the momentum and energy conservation equations, and the granular energy conservation equation contains a term which represents the dissipation of energy due to inelastic collisions. A fundamental length scale in the flow is the 'conduction length' delta = (d/(1 - e(n))(1/2)), which is the length over which the rate of conduction of energy is comparable to the rate of dissipation. Here, d is the particle diameter and e(n) is the normal coefficient of restitution. For a thick granular layer with height h delta, the flow in the bulk is analysed using an asymptotic analysis in the small parameter delta/h. In the leading approximation, the rate of conduction of energy is small compared to the rates of production and dissipation, and there is a balance between the rate of production due to mean shear and the rate of dissipation due to inelastic collisions. A direct consequence of this is that the volume fraction in the bulk is a constant in the leading approximation. The first correction due to the conduction of energy is determined using asymptotic analysis, and is found to be O(delta/h)(2) smaller than the leading-order volume fraction. The numerical value of this correction is found to be negligible for systems of practical interest, resulting in a lack of variation of volume fraction with height in the bulk. The flow in the 'conduction boundary layers' of thickness comparable to the conduction length at the bottom and top is analysed. Asymptotic analysis is used to simplify the governing equations to a second-order differential equation in the scaled cross-stream coordinate, and the resulting equation has the form of a diffusion equation. However, depending on the parameters in the constitutive model, it is found that the diffusion coefficient could be positive or negative. Domains in the parameter space where the diffusion coefficients are positive and negative are identified, and analytical solutions for the boundary layer equations, subject to appropriate boundary conditions, are obtained when the diffusion coefficient is positive. There is no boundary layer solution that matches the solution in the bulk for parameter regions where the diffusion coefficient is negative, indicating that a steady solution does not exist. An analytical result is derived showing that a boundary layer solution exists (diffusion coefficient is positive) if, and only if, the numerical values of the viscometric coefficients are such that volume fraction in the bulk decreases as the angle of inclination increases. If the numerical values of the viscometric coefficients are such that the volume fraction in the bulk increases as the angle of inclination increases, a boundary layer solution does not exist. The results are extended to dense flows in thin layers using asymptotic analysis. Use is made of the fact that the pair distribution function is numerically large for dense flows, and the inverse of the pair distribution function is used as a small parameter. This approximation results in a nonlinear second-order differential equation for the pair distribution function, which is solved subject to boundary conditions. For a dissipative base, it is found that a flowing solution exists only when the height is larger than a critical value, whereas the temperature decreases to zero and the flow stops when the height becomes smaller than this critical value. This is because the dissipation at the base becomes a larger fraction of the total dissipation as the height is decreased, and there is a minimum height below which the rate of production due to shear is not sufficient to compensate for the rate of dissipation at the base. The scaling of the minimum height with dissipation in the base, the bulk volume fraction and the parameters in the constitutive relations are d
机译:使用从动力学理论推导的本构关系分析了粗糙的非弹性颗粒在倾斜平面上的致密颗粒流动的流体力学。基本方程是动量方程和能量守恒方程,而颗粒状能量守恒方程包含一个术语,代表由于非弹性碰撞而导致的能量耗散。流中的基本长度标度是“传导长度” delta =(d /(1-e(n))(1/2)),这是能量传导率与速率可比的长度耗散。此处,d为粒径,e(n)为法向恢复系数。对于高度为h delta的厚颗粒层,使用小参数delta / h的渐近分析来分析本体中的流量。在先导近似中,能量的传导速率与生产和散逸的速率相比较小,并且在平均剪切力引起的生产速率与非弹性碰撞引起的耗散速率之间存在平衡。这样做的直接结果是,体积的体积分数在前导近似中是一个常数。使用渐近分析确定由于能量传导而产生的第一次校正,并且发现该校正量小于前导体积分数O(delta / h)(2)。发现该校正的数值对于具有实际意义的系统可以忽略不计,从而导致体积分数随体积高度的变化而变化。分析了厚度与底部和顶部的传导长度相当的“传导边界层”中的流动。使用渐近分析将控制方程简化为缩放后的横流坐标中的二阶微分方程,所得方程具有扩散方程的形式。但是,根据本构模型中的参数,发现扩散系数可以为正或负。确定扩散系数为正和负的参数空间中的域,并在扩散系数为正时获得适用于适当边界条件的边界层方程的解析解。对于扩散系数为负的参数区域,没有与整体中的溶液相匹配的边界层溶液,这表明不存在稳定的溶液。得出的分析结果表明,当且仅当粘度系数的数值使得随着倾斜角度的增加,体积中的体积分数减小时,边界层溶液才存在(扩散系数为正)。如果粘度系数的数值使得随着倾斜角的增加,本体中的体积分数增加,则不存在边界层解。使用渐近分析将结果扩展到薄层中的致密流。利用这样的事实,即,对于稠密的流,对分布函数在数值上较大,而对分布函数的反函数用作较小的参数。该近似导致对分布函数的非线性二阶微分方程,该方程在边界条件下求解。对于耗散基,发现仅当高度大于临界值时才存在流动解,而当高度小于该临界值时温度降至零且流动停止。这是因为随着高度的减小,底部的耗散占总耗散的较大部分,并且存在最小高度,低于该最小高度,由于剪切而产生的生产率不足以补偿底部的耗散率。最小高度的标度与底部的耗散,体积分数和本构关系中的参数为d

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号