首页> 外文期刊>Waste Management >Investigation on the low-temperature pyrolysis of automotive shredder residue (ASR) for energy recovery and metal recycling
【24h】

Investigation on the low-temperature pyrolysis of automotive shredder residue (ASR) for energy recovery and metal recycling

机译:汽车废渣残渣的低温热解以回收能量和回收金属的研究

获取原文
获取原文并翻译 | 示例
       

摘要

The automotive shredder residue (ASR) or shredder light fraction (SLF) is the remaining fraction from the metal recovery of end-of-life vehicles (ELVs). While processes for metal recovery from ELVs are well developed, the similar process for ASR remains a challenge. In this work, low-temperature pyrolysis of the ASR fraction was investigated under the assumption that a low temperature and inert environment would enhance the metal recovery, i.e. the metals would not be further oxidised from their original state and the organic material could be separated from the metals in the form of volatiles and char. Pyrolysis experiments were performed in a tube reactor operating at 300, 400 and 500 degrees C. The gas and oil obtained by pyrolysis were analysed by micro-GC (micro-Gas Chromatography) and GC/MS (Gas Chromatography/Mass Spectrometry), respectively. It was found that the gas produced contained a high amount of CO2, limiting the energy recovery from this fraction. The oil consisted of a high concentration of phenolic and aromatic compounds. The solid residue was crushed and fractionated into different particle sizes for further characterization. The pyrolysis temperature of 300 degrees C was found to be insufficient for metal liberation, while the char was easier to crush at tested temperature of 400 and 500 degrees C. The intermediate temperature of 400 degrees C is then suggested for the process to keep the energy consumption low. (C) 2018 Elsevier Ltd. All rights reserved.
机译:汽车碎纸机残留物(ASR)或碎纸机轻质馏分(SLF)是报废车辆(ELV)的金属回收中剩余的馏分。尽管从ELV中回收金属的方法已经开发完善,但类似的ASR工艺仍然是一个挑战。在这项工作中,在低温和惰性环境会提高金属回收率的假设下研究了ASR馏分的低温热解,即金属不会从其原始状态进一步氧化,并且有机物可能会从以挥发物和炭的形式存在的金属。在分别于300、400和500摄氏度下运行的管式反应器中进行热解实验。分别通过微型GC(微气相色谱)和GC / MS(气相色谱/质谱)分析通过热解获得的气体和油。 。发现所产生的气体包含大量的CO 2,限制了从该馏分中回收能量。该油由高浓度的酚和芳族化合物组成。将固体残余物压碎并分馏成不同的粒径,以进行进一步表征。发现300摄氏度的热解温度不足以释放金属,而炭在400和500摄氏度的测试温度下更容易破碎。建议将中间温度设为400摄氏度以保持能量消耗低。 (C)2018 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号