首页> 外文期刊>Waste management & research >Compressibility and shear strength of municipal solid waste under short-term leachate recirculation operations
【24h】

Compressibility and shear strength of municipal solid waste under short-term leachate recirculation operations

机译:短期渗滤液再循环操作下城市固体废物的可压缩性和剪切强度

获取原文
获取原文并翻译 | 示例
       

摘要

This paper describes a comprehensive laboratory study performed to investigate the compressibility and shear strength properties of 1.5-year-old municipal solid waste (MSW) exhumed from a landfill cell where low amounts of leachate were recircu-lated. The study results are compared with results from a previous study on fresh MSW collected from the same landfill and data from previous studies with known MSW age to assess the variation in properties due to degradation. Laboratory testing was conducted on shredded landfilled and fresh MSW that consisted of similar particle-size distribution, with maximum particle size less than 40 mm and approximately 80% of the waste consisting of particles ranging from 10 to 20 mm. Standard Proctor, compressibility, direct shear, and triaxial consolidated undrained (CU) shear tests were conducted in general accordance with the American Society of Testing and Materials Standard Procedures. These tests were conducted with samples at an in-situ moisture content of 44% (dry weight basis) as well as elevated moisture contents of 60, 80 and 100% (dry weight basis). Standard Proctor compaction tests yielded a maximum dry density of 600 kg/m~3 at 77% optimum moisture content for landfilled MSW compared to the 420 kg/m~3 maximum dry density at 70% optimum moisture content for fresh MSW. Compression ratio values for land-filled MSW varied in a close range of 0.19-0.24 with a slight increasing trend with increase in moisture content; however, for fresh waste they were in the close range of 0.24-0.33 with no definitive correlation with moisture content. Based on direct shear tests, drained cohesion and friction angle were varied in the range of 12-64 kPa and 31-35° for landfilled MSW and 31-64 kPa and 26-30° for fresh MSW. Neither cohesion nor friction angle demonstrated any correlation with the moisture content. Based on triaxial CU tests, the average total strength parameters (TSP) were found to be 39 kPa and 12° for landfilled MSW and 32 kPa and 12° for fresh MSW, while effective strength parameters (ESP) were 34 kPa and 23° for landfilled MSW and 32 kPa and 16° for fresh MSW. This study was limited to small-scale laboratory testing using MSW samples with the specimen size relative to the maximum particle size in the range of 1.6 to 2.6; therefore, large-scale laboratory and field studies are recommended to systematically assess the influence of composition, particle size distribution and specimen size on the geotechnical properties of MSW.
机译:本文描述了一项全面的实验室研究,以调查从垃圾渗滤液池中渗出的1.5年历史的生活垃圾(MSW)的可压缩性和抗剪强度特性,该垃圾池中再循环了少量的渗滤液。将研究结果与先前研究的相同垃圾填埋场收集的新鲜MSW的结果以及已知MSW年龄的先前研究的数据进行比较,以评估由于降解引起的性能变化。实验室测试是对切碎的垃圾填埋场和新鲜的城市固体废弃物进行的,这些废弃物具有相似的粒径分布,最大粒径小于40毫米,约80%的废物由10至20毫米的颗粒组成。一般根据美国试验和材料协会标准程序进行标准Proctor,可压缩性,直接剪切和三轴固结不排水(CU)剪切测试。这些测试是用原位水分含量为44%(以干重计)以及升高的水分含量为60%,80%和100%(以干重计)的样品进行的。标准的Proctor压实测试得出,垃圾填埋城市固体废弃物的最佳水分含量为77%时,最大干密度为600 kg / m〜3,而新鲜垃圾城市固体废弃物的最佳水分含量为70%时为420 kg / m〜3最大干密度。垃圾填埋场的压缩比值在0.19-0.24的范围内变化,随着含水量的增加略有增加。但是,对于新鲜废物,它们在0.24-0.33的范围内,与水分含量没有明确的相关性。根据直接剪切试验,排泄的内聚力和摩擦角在垃圾填埋场的12-64 kPa和31-35°范围内,新鲜垃圾在31-64 kPa和26-30°的范围内变化。内聚力和摩擦角均未显示出与水分含量的任何相关性。根据三轴CU测试,发现垃圾填埋城市固体垃圾的平均总强度参数(TSP)为39 kPa和12°,新鲜垃圾城市固体垃圾的平均总强度参数(TSP)为34 kPa和23°填埋的MSW,新鲜的MSW为32 kPa和16°。本研究仅限于使用MSW样品进行的小型实验室测试,样品尺寸相对于最大粒径在1.6至2.6范围内。因此,建议进行大规模的实验室和现场研究,以系统地评估组成,粒径分布和样本尺寸对城市固体废弃物岩土性能的影响。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号