首页> 外文期刊>Sensors Journal, IEEE >Development of Tablet-Shaped Ingestible Core-Body Thermometer Powered by Gastric Acid Battery
【24h】

Development of Tablet-Shaped Ingestible Core-Body Thermometer Powered by Gastric Acid Battery

机译:胃酸电池供电的平板式可吸收人体温度计的研制

获取原文
获取原文并翻译 | 示例
           

摘要

In this paper, we have developed a tablet-shaped ingestible core-body temperature sensor based on gastric acid power generation for daily health care. A custom integrated circuit (IC), which had voltage boosting, bit-rate conversion, coding, modulating, and transmitting functions, was prototyped for the feasibility study of this system. A pair of Mg and Au electrodes was chosen as the negative and positive electrodes for the gastric acid battery, respectively. The battery with a diameter of 2 mm in an artificial gastric juice generated approximately 1.2 V of output voltage. Subsequently, it successfully boosted the generated voltages to more than 3.5 V by the custom IC and demonstrated the charging of a multilayer ceramic capacitor at the boosted voltage within a reasonably short time. The feasibility of mass production of the Mg thin-film-based battery on a print circuit board (PCB) was also verified through sputter deposition of a Mg thin film on a Au pad of a PCB. Next, electrical components of diameter approximately 7 mm were mounted on the PCBs and compactly packaged with a resin. Consequently, a tablet-shaped device of diameter 10 mm and height 8 mm was prototyped as a specimen for a telemetry experiment. Finally, we successfully demonstrated that the temperature data measured by the device in pork were transferred to a commercially available loop antenna as a receiver at a distance of more than 20 cm via magnetic-field coupling telecommunication. This achievement paves the way to realizing a safe and ingestible core-body thermometer for daily use.
机译:在本文中,我们开发了一种基于胃酸发电的平板形可摄入核心体温传感器,用于日常保健。定制的具有升压,比特率转换,编码,调制和传输功能的集成电路(IC)原型用于该系统的可行性研究。选择一对Mg和Au电极分别作为胃酸电池的负极和正极。人造胃液中直径为2毫米的电池产生约1.2 V的输出电压。随后,它通过定制IC成功地将产生的电压升压到3.5 V以上,并展示了在合理的短时间内以升压电压对多层陶瓷电容器进行充电的过程。还通过将Mg薄膜溅射沉积在PCB的Au焊盘上来验证在印刷电路板(PCB)上大规模生产Mg薄膜电池的可行性。接下来,将直径约为7毫米的电气组件安装在PCB上,并用树脂紧密封装。因此,将直径为10毫米,高度为8毫米的平板形设备作为遥测实验的样本原型。最后,我们成功地证明了该设备在猪肉中测得的温度数据已通过磁场耦合电信技术以20厘米以上的距离传输到市售的环形天线作为接收器。这一成就为实现日常使用的安全且可摄入的核心体温计铺平了道路。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号