...
首页> 外文期刊>Power Systems, IEEE Transactions on >Quantification of Additional Reinforcement Cost Driven by Voltage Constraint Under Three-Phase Imbalance
【24h】

Quantification of Additional Reinforcement Cost Driven by Voltage Constraint Under Three-Phase Imbalance

机译:三相不平衡下受电压约束驱动的附加加固成本的量化

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Three-phase imbalance causes uneven voltage drops across LV transformers and main feeders. With continuous load growth, the lowest phase voltage at the feeder end determines the voltage spare room, which is lower than if the same power were transmitted through balanced three phases. This imbalance causes additional reinforcement cost (ARC) beyond the balanced case. This paper proposes novel ARC models for a typical LV circuit based on primary-side voltage and current measurements. All models except the accurate model not only enable efficient utility-scale ARC calculations with sufficient accuracy but also remove the need for phasor measurements. The ARC models calculate voltage-driven reinforcement costs for the imbalanced case and the benchmark, i.e., the balanced case, where the ARC is the difference between the above values. The models include: an accurate ARC model considering imbalance in both magnitudes and phase angles; a semi-simplified ARC model assuming balanced phase angles; a fully simplified model assuming a purely resistive LV circuit and a unity power factor; and linearized ARC models considering the imbalance degree for two special cases. Test case proves that: the ARC is a monotonically increasing, convex (concave) but close-to-linear function of current (voltage) imbalance; voltage imbalance has a greater impact on ARCs than current imbalance; a higher degree of current imbalance and/or a deteriorating power factor reduce the accuracy of the fully simplified model; and the accuracy of the semi-simplified model is higher in the case of voltage angle imbalance than in the case of current angle imbalance.
机译:三相不平衡会导致低压变压器和主馈线两端的电压降不均匀。在负载持续增长的情况下,馈线端的最低相电压决定了电压备用空间,该电压备用空间低于通过平衡的三相传输相同功率的情况。这种不平衡会导致超出平衡情况的额外加固成本(ARC)。本文基于一次侧电压和电流测量结果为典型的低压电路提出了新颖的ARC模型。除精确模型外,所有模型都不仅能够以足够的精度进行有效的公用事业规模ARC计算,而且消除了对相量测量的需求。 ARC模型针对不平衡情况和基准(即平衡情况)计算电压驱动的加固成本,其中ARC是上述值之间的差。这些模型包括:考虑幅度和相位角不平衡的精确ARC模型;假设相位角平衡的半简化ARC模型;一个完全简化的模型,假设一个纯电阻LV电路和一个统一的功率因数;考虑了两种特殊情况下的不平衡度的线性化ARC模型。测试案例证明:ARC是电流(电压)不平衡的单调递增,凸(凹)但接近线性的函数;与电流不平衡相比,电压不平衡对ARC的影响更大;较高程度的电流不平衡和/或功率因数恶化会降低完全简化模型的准确性;电压角不平衡情况下的半简化模型的精度高于电流角不平衡情况下的半简化模型的精度。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号