首页> 外文期刊>Marine pollution bulletin >A study on characteristics of microplastic in wastewater of South Korea: Identification, quantification, and fate of microplastics during treatment process
【24h】

A study on characteristics of microplastic in wastewater of South Korea: Identification, quantification, and fate of microplastics during treatment process

机译:韩国废水中微塑料的特性研究:处理过程中微塑料的鉴定,定量和结局

获取原文
获取原文并翻译 | 示例
       

摘要

This study investigated the removal of microplastics from different treatment stages in three WWTPs and examined the performance of tertiary treatment that was done by coagulation and different technologies such as ozone (WWTP-A), membrane disc-filter (WWTP-B), and rapid sand filtration (WWTP-C). The results showed that the primary and secondary treatment processes effectively remove microplastics from wastewater with efficiencies ranging between 75% and 91.9%. The removal efficiency increased further to > 98% after tertiary treatment. Microbeads and fragments were the major types of microplastics found in all wastewater sampling points. Microbeads found in the wastewater samples were classified as primary microplastics, that mainly came from personal care products, whereas secondary microplastics consisted of fragments, fibers, and sheets that were generated mainly due to fragmentation of larger plastics. Microplastics were still found in a high concentration in the final effluent, especially from WWTP-B, which is discharged into the Geumho river.
机译:这项研究调查了三个污水处理厂中不同处理阶段的微塑料的去除情况,并研究了通过混凝和不同技术(例如臭氧(WWTP-A),膜片式滤池(WWTP-B)和快速处理)进行的三级处理的性能。砂滤(WWTP-C)。结果表明,一次和二次处理过程可有效去除废水中的微塑料,效率在75%至91.9%之间。三级处理后,去除效率进一步提高到> 98%。在所有废水采样点中,微珠和碎片是微塑料的主要类型。废水样品中发现的微珠被分类为主要的微塑料,主要来自个人护理产品,而次要的微塑料则由碎片,纤维和薄片组成,这些碎片,纤维和薄片主要是由于较大的塑料碎裂而产生的。最终废水中仍发现高浓度的微塑料,尤其是废水处理厂废水中的微塑料,废水排放到了金姆霍河。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号