...
首页> 外文期刊>Journal of Polymers and the Environment >Glutaraldehyde as Ambient Temperature Crosslinking Agent of Latex Films from Natural Rubber Grafted with Poly(diacetone acrylamide)
【24h】

Glutaraldehyde as Ambient Temperature Crosslinking Agent of Latex Films from Natural Rubber Grafted with Poly(diacetone acrylamide)

机译:戊二醛作为天然橡胶与聚二丙酮丙烯酰胺接枝的乳胶薄膜的环境温度交联剂

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

The concept of using glutaraldehyde (GTA) to crosslink natural rubber (NR) particles bearing diacetone acrylamide (DAAM) functional groups during film formation was investigated in the present work. The primary advantage of this curing system is that it is feasible under ambient conditions, which can lower operating costs of the curing process. Graft copolymers of NR and poly(diacetone acrylamide) prepared with 5 wt% of DAAM (NR-g-PDAAM5) were synthesized by seeded emulsion polymerization at 50 A degrees C. Then, the tensile properties were measured for cast films formed from NR-g-PDAAM5 latex in the absence and presence of GTA. The results revealed increased tensile strength of the NR-g-PDAAM5 film, when GTA was added into the latex prior to film casting. The crosslinking of NR-g-PDAAM5 latex film by reaction with GTA, after film casting, was also investigated using attenuated total reflection Fourier transform infrared (ATR-FTIR) and dynamic mechanical thermal analysis (DMTA). ATR-FTIR analysis demonstrated that crosslinking reactions formed conjugated C=C double bonds between the active carbonyl groups of DAAM and GTA. The complementary use of DMTA also corroborated that crosslinking reactions took place involving the grafted PDAAM chains on the NR particles. This was evidenced by a clear shift towards higher temperatures of the tan delta peak, corresponding to the T (g) of NR-g-PDAAM phase, when GTA was incorporated into the NR-g-PDAAM5 latex before film formation. Additionally, a noticeable increase in thermal stability of the NR-g-PDAAM5 film was also observed with added GTA. Hence, it can be concluded that GTA is an efficient room-temperature crosslinker for NR particles functionalized with DAAM. This curing system can also be considered an alternative, simple, and inexpensive method for curing NR latex compounds, as only one component (GTA) is required in the curing process.
机译:在本工作中,研究了在膜形成过程中使用戊二醛(GTA)交联带有双丙酮丙烯酰胺(DAAM)官能团的天然橡胶(NR)颗粒的概念。该固化系统的主要优点是在环境条件下可行,这可以降低固化过程的运行成本。在50 A的温度下通过种子乳液聚合法合成由5%的DAAM(NR-g-PDAAM5)制备的NR和聚二丙酮丙烯酰胺的接枝共聚物。然后,测量由NR-形成的流延膜的拉伸性能在没有和存在GTA的情况下使用g-PDAAM5乳胶。结果表明,在薄膜浇铸之前向乳胶中添加GTA时,NR-g-PDAAM5薄膜的拉伸强度有所提高。还使用衰减全反射傅立叶变换红外光谱(ATR-FTIR)和动态机械热分析(DMTA)研究了薄膜浇铸后,NR-g-PDAAM5乳胶薄膜与GTA发生的交联。 ATR-FTIR分析表明,交联反应在DAAM和GTA的活性羰基之间形成了共轭的C = C双键。 DMTA的补充使用也证实了发生了交联反应,涉及到NR颗粒上的接枝PDAAM链。当在薄膜形成之前将GTA掺入NR-g-PDAAM5胶乳中时,tanδ峰明显向较高的温度转移,这对应于NR-g-PDAAM相的T(g)证明了这一点。此外,添加GTA还可观察到NR-g-PDAAM5膜的热稳定性显着提高。因此,可以得出结论,GTA是用于DAAM功能化的NR颗粒的高效室温交联剂。该固化系统也可以被认为是一种用于固化NR胶乳化合物的替代,简单且廉价的方法,因为在固化过程中仅需要一种组分(GTA)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号