首页> 外文期刊>Journal of Polymers and the Environment >Optimized Removal of Acid Blue 62 from Textile Waste Water by SBA-15/PAMAM Dendrimer Hybrid Using Response Surface Methodology
【24h】

Optimized Removal of Acid Blue 62 from Textile Waste Water by SBA-15/PAMAM Dendrimer Hybrid Using Response Surface Methodology

机译:响应面法优化SBA-15 / PAMAM树枝状大分子杂化剂对纺织废水中酸性蓝62的优化去除

获取原文
获取原文并翻译 | 示例
       

摘要

SBA-15/PAMAM Nano adsorbent was synthesized by the proficiency of SBA-15 as an original compound, 3-chloropropyltrimethoxysilane as a bridge chemical compound and polyamidoamine dendrimer (PAMAM) in the role of a multifunctional amine end group for adsorption of acid blue 62 (AB62) from aqueous media. The synthesized adsorbent was characterized by transmission electron microscope, field emission scanning electron microscope and Fourier-transform infrared spectroscope. A response surface methodology was employed to evaluate the simple and amalgamated factors of the operating variables subtending initial pH (2-12), adsorbent dosage(0.01-0.03 g), contact time (5-120 min), initial dye concentration (40-600 ppm) and temperature (25-45 A degrees C) to optimize the operating statues of the treatment method. These parameters were altered at five levels pursuant to the central composite design to appraise their effects on AB62 removal through analysis of variance. Analysis of variance represented a high coefficient of definition amount (R-2 = 0.9999) and acceptable prediction quadratic polynomial model was concluded which ascertain the suitability of the model and a high correlation among the predicted and empirical amounts. Utmost color removal efficiency was auspicated and empirically accredited. The optimum conditions relied on acquired results for AB62 removal were at an initial pH of 2, adsorbent dosage of 0.03 g SBA-15/PAMAM, dye concentration of 40 mg l(-1), time contact of 60 min and temperature of 25 A degrees C.
机译:SBA-15 / PAMAM纳米吸附剂是由SBA-15作为原始化合物,3-氯丙基三甲氧基硅烷作为桥联化合物和聚酰胺基胺树枝状大分子(PAMAM)合成的,该复合物具有多功能胺端基,可吸附酸性蓝62 (AB62)来自水性介质。用透射电子显微镜,场发射扫描电子显微镜和傅立叶变换红外光谱仪对合成的吸附剂进行了表征。采用响应面方法评估了影响初始pH(2-12),吸附剂剂量(0.01-0.03 g),接触时间(5-120 min),初始染料浓度(40- 600 ppm)和温度(25-45 A摄氏度)以优化处理方法的运行状态。根据中央复合设计,将这些参数在五个级别上进行了更改,以通过方差分析评估它们对AB62去除的影响。方差分析表示高定义量系数(R-2 = 0.9999),得出了可接受的预测二次多项式模型,该模型确定了模型的适用性,并且预测量和经验量之间具有高度相关性。最高的脱色效率得到了经验证明。取决于获得的结果去除AB62的最佳条件是初始pH为2,吸附剂量为0.03 g SBA-15 / PAMAM,染料浓度为40 mg l(-1),接触时间为60 min,温度为25 A摄氏度

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号