...
首页> 外文期刊>Journal of nuclear science and technology >Durability of Irradiated Polymers in Solid-Polymer-Electrolyte Water Electrolyzer
【24h】

Durability of Irradiated Polymers in Solid-Polymer-Electrolyte Water Electrolyzer

机译:固体聚合物电解质水电解槽中辐照聚合物的耐久性

获取原文
获取原文并翻译 | 示例
           

摘要

The durability of irradiated organic polymers in solid-polymer-electrolyte water electrolyzer was investigated by gamma-ray irradiation tests around 500 kGy. Serious deteriorations for the tensile strength and ion exchange capacity of the ion exchange membrane (Nafion~®) were not observed up to 850 kGy. No serious damage was also observed for tensile strength of the gasket materials (Aflas~®) up to 500 kGy. The insulator materials (PFA and FEP) lost their tensile strength at 200 kGy and 300 kGy, respectively. From the above results, we can safely say that the electrolysis cell could be used up to around 500 kGy of irradiation conditions in the case where PFA and FEP are replaced by the polyimide resin which durability against the irradiation is well demonstrated. Two degrading mechanisms were supposed as the effect of irradiation. One is the direct degradation of the chain and branch by gamma-ray. The other is degradation by the attack of radicals. It was demonstrated that the effect of radicals on degradation of the membrane was not dominant. In addition, oxygen was observed to have a large influence on degradation. The quantity of dissolved fluorine in water that could be measured easily was found to correlate closely with tensile strength and ion exchange capacity. Hence, it is possible to evaluate the degradation of ion exchange membrane by monitoring the quantity of dissolved fluorine in water. Concerning the difference of degrading mechanism of the ion exchange membrane due to irradiation source, the combinations of tensile strength, ion exchange capacity and quantity of dissolved fluorine are proposed as deterioration indexes.
机译:通过约500 kGy的伽马射线辐照试验研究了固体聚合物电解质水电解槽中辐照的有机聚合物的耐久性。在850 kGy以下,未观察到离子交换膜(Nafion®)的拉伸强度和离子交换能力的严重降低。高达500 kGy的垫片材料(Aflas®)的拉伸强度也未观察到严重损坏。绝缘材料(PFA和FEP)分别失去了200 kGy和300 kGy的拉伸强度。根据上述结果,可以肯定地说,在用聚酰亚胺树脂代替PFA和FEP的情况下,电解槽可以在高达500 kGy的辐照条件下使用,这充分证明了其对辐照的耐久性。两种降解机理被认为是辐射的作用。一种是伽玛射线直接降解链和支链。另一类是自由基攻击导致的降解。已证明自由基对膜降解的影响不是主要的。此外,观察到氧气对降解有很大的影响。发现水中易于溶解的氟的含量与拉伸强度和离子交换能力密切相关。因此,可以通过监测水中氟的溶解量来评估离子交换膜的降解。关于离子交换膜由于照射源而引起的降解机理的差异,提出将拉伸强度,离子交换容量和氟的溶解量的组合作为劣化指标。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号