首页> 外文期刊>Journal of Mineralogical and Petrological Sciences >Textures of plagioclase microlite and vesicles within volcanic products of the 1914-1915 eruption of Sakurajima Volcano, Kyushu, Japan
【24h】

Textures of plagioclase microlite and vesicles within volcanic products of the 1914-1915 eruption of Sakurajima Volcano, Kyushu, Japan

机译:1914年至1915年日本九州樱岛火山喷发的火山产物中斜长石微晶和囊泡的质地

获取原文
获取原文并翻译 | 示例
           

摘要

We classify volcanic products of the 1914-1915 eruption of Sakurajima Volcano into four types according to vesicularity and the texture of plagioclase microlite. Type-1 is white Plinian fall pumice with high vesicularity ( > 60 vol%) and low modal content ( < 1.0 vol%) and number density (< 10~(14) m~(-3)) of microlite. Type-2 is white Plinian fall pumice with high vesicularity ( > 55 vol%) and intermediate modal content (1.0 11.0 vol%) and number density (110 x 10~(14) m~(-3)) of microlite. Type-3 is slightly darker Plinian fall pumice with low vesicularity (25-50 vol%) and intermediate to high modal content (8 16 vol%) and number density (5 x 10~(14)-2 x 10~(15) m~(-3)) of microlite. The fourth type of volcanic product is lava flows with low vesicularity ( < 25 vol%) and high modal content ( > 16 vol%) and intermediate number density (1-5 x 10~(14) m~(-3)) of plagioclase microlite. Type-1 and type-2 pumices were mainly deposited within the lower and middle parts of the Plinian fall deposit, whereas type-3 pumices were mainly deposited in the upper part. Homogeneous chemical features of preemptive melts of all types of pumices indicate that the observed variations in number density and modal content of plagioclase microlite, as well as the decreasing vesicularity from type-1 to type-3 pumices, are related to a decrease in the decompression rate of magma from early to late stages of the Plinian phase. Residual water contents and degree of vesicularity of Plinian fall pumices suggest a change in the degassing process during the Plinian phase of eruption from minor degassing during the eruption of type-1 pumices to effective degassing during the eruption of type-3 pumices. Differences in microlite texture between type-1 and type-2 pumices of the early to middle stages of the Plinian phase and late stage type-1,-2 and -3 pumices reflect changes in the decompression rate, perhaps related to differences between the central and marginal parts of conduits. A systematic increase in the An content of plagioclase microlites from Plinian fall pumice to Taisho Lava reflects a chemical change in the preemptive melt from silicic to basic composition related to progressive magma mixing.
机译:根据小泡和斜长石微晶岩的质地,我们将樱岛火山1914年至1915年的火山喷发分为四种类型。 Type-1是白色的Plinian秋季浮石,具有高泡状(> 60 vol%)和低模态含量(<1.0 vol%)和微晶石的数密度(<10〜(14)m〜(-3))。 2型是白色的Plinian秋季浮石,具有高泡状(> 55 vol%)和中等模式含量(1.0 11.0 vol%),微晶的数密度(110 x 10〜(14)m〜(-3))。 Type-3是较暗的Plinian秋季浮石,具有低水泡性(25-50%(体积))和中高模态含量(8-16%(体积))和数密度(5 x 10〜(14)-2 x 10〜(15)) m〜(-3))。第四类火山产物是熔岩流,其小泡度(<25 vol%)和高模态含量(> 16 vol%)和中间数密度(1-5 x 10〜(14)m〜(-3))为斜长石微晶。 1型和2型浮石主要沉积在Plinian秋季沉积的下部和中部,而3型浮石主要沉积在上部。所有类型浮石的抢先熔体的均质化学特征表明,斜长石微晶的数量密度和模态含量的观察到的变化,以及从1型浮石到3型浮石的囊泡性下降与减压的降低有关。普利尼期早期到后期的岩浆速率。 Plinian秋季粉刺的残留水含量和囊泡程度表明,在Plinian喷发阶段,脱气过程从1型粉刺喷发时的少量脱气到3型粉刺喷发期间的有效脱气有所变化。 Plinian相早期至中期的1型和2型浮石与后期的1,-2型和-3型浮石的微晶质感差异反映了减压速率的变化,这可能与中央部位的差异有关。和导管的边缘部分。从Plinian秋季浮石到Taisho熔岩的斜长石微晶石中An含量的系统增加反映了先发性熔体的化学变化,从硅质到基本成分与渐进性岩浆混合有关。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号