PostcombustionCO_2 Capture for Combined Cycles Utilizing Hot-Water Absorbent Regeneration

摘要

The partly hot-water driven CO 2 capture plant offers a significant potential for improvement in performance when implemented in a combined-cycle power plant (CCPP). It is possible to achieve the same performance with a dual-pressure steam cycle as in a triple-pressure unit. Even a single-pressure plant can attain an efficiency competitive with that achievable with a triple-pressure plant without the hot-water reboiler. The underlying reasons are better heat utilization in the heat recovery unit and less steam extraction to the absorbent regenerating unit(s). In this paper, the design criteria for a combined cycle power plant utilizing hot-water absorbent regeneration will he examined and presented. The results show that the most suitable plant is one with two steam pressure levels. The low-pressure level should be much higher than in a conventional combined cycle in order to increase the amount of heat available in the economizer. The external heat required in the CO_2 capture plant is partly supplied by the economizer, allowing temperature optimization in the unit. The maximum value of the low-pressure level is determined by the reboiler, as too great a temperature difference is unfavorable. This work evaluates the benefits of coupling the economizer and the reboiler in a specially designed CCPP. In the CO_2 separation plant both monoethanolamine (MEA) and ammonia are evaluated as absorbents. Higher regeneration temperatures can be tolerated in ammonia-based plants than in MEA-based plants. When using a liquid heat carrier the reboiler temperature is not constant on the hot side, which results in greater temperature differences. The temperature difference can be greatly reduced by dividing the regeneration process into two units operating at different pressures. The possibility of extracting more energy from the economizer to replace part of the extracted steam increases the plant efficiency. The results show that very high efficiencies can be achieved without using multiple pressure-levels.