Recycling of waste glass generated from end-of-life LCD devices: A feasibility study using simulated waste glass

摘要

The liquid crystal display (LCD) industry has undergone drastic growth over the past decade. Considering that the lifetime of an LCD device is approximately ten years, a huge end LCD waste glass (ELWG) is being produced from end-of-life LCD devices. The recycling of ELWG derived from LCD device produced before 2011 is limited by the presence of toxic components such as As, Sb and Ba. In this work, the potential of recycling ELWG was examined to be used in the glass wool industry. 17 glass batches using four different simulated ELWGs (mixtures corresponding to LCD glasses produced in 2006, 2008, 2009, and 2010) were prepared and melted. ELWG was introduced up to 20% of the total glass. Two fixed viscosity points (T-m, T-w) corresponding to 102 and 103 dPas, and the liquidus temperature (T-L) were determined in the melt state, and leaching tests of the glass powder in an acidic solution based on the toxicity characteristic leaching procedure (TCLP) were also carried out. As the ELWG content was increased, the T-m, Tw, and T-L values did not show a linear relationship with the ELWG content, but some fluctuation in the values was observed. The Tm value showed a larger deviation of 28-36 degrees C from that of the original glass than the T-w (6-14 degrees C) and T-L (2-16 degrees C) values. As and Sb were not detected in the leaching tests, and the Ba concentration (1.232-2.279 mg/L) was much lower than the TCLP regulatory level (100 mg/L). The observed T-w-T-L values suggested that the replacement of 20% or more of the total glass by ELWG is possible. Additionally, the economic and environmental effects of the recycling process were discussed. (C) 2019 Elsevier Ltd. All rights reserved.