首页> 外文期刊>ISPRS Journal of Photogrammetry and Remote Sensing >Prospects of the ICESat-2 laser altimetry mission for savanna ecosystem structural studies based on airborne simulation data
【24h】

Prospects of the ICESat-2 laser altimetry mission for savanna ecosystem structural studies based on airborne simulation data

机译:基于机载模拟数据的ICESat-2激光测高任务在稀树草原生态系统结构研究中的前景

获取原文
获取原文并翻译 | 示例
       

摘要

The next planned spaceborne lidar mission is the Ice, Cloud and land Elevation Satellite 2 (ICESat-2), which will use the Advanced Topographic Laser Altimeter System (ATLAS) sensor, a photon counting technique. To pre-validate the capability of this mission for studying three dimensional vegetation structure in savannas, we assessed the potential of the measurement approach to estimate canopy height in an oak savanna landscape. We used data from the Multiple Altimeter Beam Experimental Lidar (MABEL), an airborne photon counting lidar sensor developed by NASA's Goddard Space Flight Center. ATLAS-like data was generated using the MATLAS simulator, which adjusts MABEL data's detected number of signal and noise photons to that expected from the ATLAS instrument. Transects flown over the Tejon ranch conservancy in Kern County, California, USA were used for this work. For each transect we chose to use data from the near infrared channel that had the highest number of photons. We segmented each transect into 50 m, 25 m and 14 m long blocks and aggregated the photons in each block into a histogram based on their elevation values. We then used an automated algorithm to identify cut off points where the cumulative density of photons from the highest elevation indicates the presence of the canopy top and likewise where such cumulative density from the lowest elevation indicates the mean terrain elevation. MABEL derived height metrics were moderately correlated to discrete return lidar (DRL) derived height metrics (r(2) and RMSE values ranging from 0.60 to 0.73 and 2.9 m to 4.4 m respectively) but MATLAS simulation resulted in more modest correlations with DRL indices (r(2) ranging from 0.5 to 0.64 and RMSE from 3.6 m to 4.6 m). Simulations also indicated that the expected number of signal photons from ATLAS will be substantially lower, a situation that reduces canopy height estimation precision especially in areas of low density vegetation cover. On the basis of the simulated data, there is reason to believe that the ability of ICESat-2 to estimate height in savannas will be comparable to the original ICESat mission although the respective sensors have different measurement principles. Published by Elsevier B.V. on behalf of International Society for Photogrammetry and Remote Sensing, Inc. (ISPRS).
机译:下一个计划进行的太空激光雷达任务是“冰,云和陆地高空卫星2(ICESat-2)”,它将使用光子计数技术高级地形激光高度计系统(ATLAS)传感器。为了预先验证该任务研究热带稀树草原三维植被结构的能力,我们评估了测量方法估计橡树稀树草原景观冠层高度的潜力。我们使用了由美国宇航局戈达德太空飞行中心开发的机载光子计数激光雷达传感器多高度计光束实验激光雷达(MABEL)的数据。使用MATLAS模拟器生成类似ATLAS的数据,该模拟器将MABEL数据的检测到的信号和噪声光子数调整为ATLAS仪器预期的数量。这项工作使用了在美国加利福尼亚州克恩县Tejon牧场保护区上空飞行的样带。对于每个样带,我们选择使用来自光子数量最多的近红外通道的数据。我们将每个样条线分割为50 m,25 m和14 m长的块,并基于它们的高程值将每个块中的光子聚集为直方图。然后,我们使用一种自动算法来确定截止点,在这些截止点处,来自最高海拔高度的光子的累积密度指示冠层的存在,同样,来自最低海拔高度的此类累积密度指示的平均地形海拔高度。 MABEL得出的高度量度与离散返回激光雷达(DRL)得出的高度量度(r(2)和RMSE值分别从0.60到0.73和2.9 m到4.4 m适度相关),但是MATLAS模拟导致与DRL指数的相关度更适中( r(2)范围从0.5到0.64,RMSE范围从3.6 m到4.6 m)。模拟还表明,来自ATLAS的信号光子的预期数量将大大减少,这种情况会降低冠层高度的估算精度,尤其是在低密度植被覆盖的地区。根据模拟数据,有理由相信,尽管各个传感器具有不同的测量原理,但ICESat-2估计热带稀树草原高度的能力将与原始ICESat任务相当。由Elsevier B.V.代表国际摄影测量与遥感学会(ISPRS)发布。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号