Ferrite Formation above the Ae_3 Temperature during the Torsion Simulation of Strip Rolling

摘要

Torsion simulations of 7-pass strip rolling were carried out on a 0.06%C-0.3%Mn-0.01%Si and a 0.11%C-1.0%Mn-0.11%Si-0.03%Al-0.034%Nb steel using pass strains of 0.4 applied at 1 s~(-1). The deformations were imposed isothermally at 910℃ and 930℃ for the C-Mn and the Nb microalloyed steel, respectively. The flow curve levels decreased from pass to pass as a result of softening by both dynamic transformation (DT) and dynamic recrystallization (DRX). The application of double differentiation to the stress-strain curves led to average critical strains for the initiation of DT and DRX of about 0.06 and 0.11, respectively. Optical microscopy revealed that the volume fraction of DT ferrite increased continuously right up to the last pass. The fraction of DT ferrite formed and retained was significantly higher when short interpass times were used. Comparison of the behaviors of the C-Mn and Nb steels indicates that Nb addition retards both the forward as well as the reverse transformation.