...
首页> 外文期刊>International journal of RF and microwave computer-aided engineering >Design of a 4.2-5.4 GHz Differential LC VCO Using 0.35 μm SiGe BiCMOS Technology for IEEE 802.11a Applications
【24h】

Design of a 4.2-5.4 GHz Differential LC VCO Using 0.35 μm SiGe BiCMOS Technology for IEEE 802.11a Applications

机译:使用0.35μmSiGe BiCMOS技术针对IEEE 802.11a应用设计4.2-5.4 GHz差分LC VCO

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

In this paper, a 4.2-5.4 GHz, -Gm LC voltage controlled oscillator (VCO) for IEEE 802.11a standard is presented. The circuit is designed with AMS 0.35 μm SiGe BiCMOS process that includes high-speed SiGe Heterojunction Bipolar Transistors (HBTs). According to post-layout simulation results, phase noise is -110.7 dBc/Hz at 1 MHz offset from 5.4 GHz carrier frequency and -113.4 dBc/Hz from 4.2 GHz carrier frequency. A linear, 1200 MHz tuning range is obtained from the simulations, utilizing accumulation-mode varactors. Phase noise was also found to be relatively low because of taking advantage of differential tuning concept. Output power of the fundamental frequency changes between 4.8 dBm and 5.5 dBm depending on the tuning voltage. Based on the simulation results, the circuit draws 2 mA without buffers and 14.5 mA from 2.5 V supply including buffer circuits leading to a total power dissipation of 36.25 mW. The circuit layout occupies an area of 0.6 mm~2 on Si substrate, including DC and RF pads.
机译:本文提出了一种用于IEEE 802.11a标准的4.2-5.4 GHz -Gm LC压控振荡器(VCO)。该电路采用AMS 0.35μmSiGe BiCMOS工艺设计,该工艺包括高速SiGe异质结双极晶体管(HBT)。根据布局后的仿真结果,相位噪声在5.4 GHz载波频率偏移1 MHz时为-110.7 dBc / Hz,而在4.2 GHz载波频率偏移为-113.4 dBc / Hz。利用累积模式变容二极管从仿真中获得线性1200 MHz调谐范围。由于利用了差分调谐概念,因此还发现相位噪声相对较低。基频的输出功率根据调谐电压在4.8 dBm至5.5 dBm之间变化。根据仿真结果,该电路在没有缓冲器的情况下汲取2 mA电流,从2.5 V电源(包括缓冲器电路)汲取14.5 mA电流,导致总功耗为36.25 mW。电路布局在包括直流焊盘和射频焊盘的Si基板上占据0.6 mm〜2的面积。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号