Ultracompact methane steam reforming reactor based on microwaves susceptible structured catalysts for distributed hydrogen production

摘要

Hydrogen is a potential green energy vector. Since the heating of the reforming processes commonly used for its production is obtained by burning hydrocarbons, it has a substantial CO2 footprint. One of the most critical aspects in the methane steam reforming (MSR) reaction is the heat transfer to the catalytic volume, due to the high heat fluxes required to obtain high methane conversions. Consequently, the reactor has complex geometries, along with the heating medium being characterized by temperatures higher than 1000 degrees C; expensive construction materials and high reaction volumes are therefore needed, resulting in slow thermal transients. These aspects increase the costs (both operative and fixed) as well as cause a decrease in the whole process efficiency. The heat transfer limitations due to the endothermicity of methane steam reforming reaction could be effectively overcome by microwave (MW) heating. This heating technique, that depends only on the dielectric properties of the materials, can result in an efficient and faster method for transferring heat directly to the catalyst, thus generating the heat directly inside the catalytic volume. In this work, Ni-based catalysts, differing from each other by the Ni loading (7 and 15 wt% with respect to the washcoat) were prepared. The catalysts were characterized by means of several techniques and tested in the MW-assisted methane steam reforming reaction. Furthermore, the energy balance of the entire process was performed to calculate the energy efficiency, making a preliminary evaluation of its feasibility in distributed hydrogen production also possible. The results of the preliminary tests showed that the prepared structured catalysts are very susceptible to the MW radiation, and that in the presence of the MSR reaction, it is possible to make the system reach a temperature of 900 degrees C. In the same tests, the CH4 conversion showed a good approach to the thermodynamic equilibrium values starting at temperatures of about 800 degrees C at a value of gas hourly space velocity (GHSV) of about 5000 h(-1). The energy efficiency of the lab-scale system, calculated as the ratio among the energy absorbed by the system and the energy supplied by the microwaves, was about 50%. Future studies will deal with the microwave reactor optimization, aiming at the increase of the energy efficiency of the system, as well as to obtain a higher CH4 conversion at lower temperatures and increase the H-2 yield and selectivity. (C) 2020 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.