Design and Development of a PCM-Based Two-Phase Heat Exchanger Manufactured Additively for Spacecraft Thermal Management Systems

摘要

For spacecraft thermal management systems, it is crucial to diminish the overall mass of on-board thermal storage system and minimize the temperature fluctuations when the environmental temperature changes drastically. Since there is no atmosphere in outer space, heat can only be rejected to space using radiation (e.g., radiators). The heat sink conditions, and the heating power subjected to be rejected vary continuously at the orbiting stage of the spacecraft. Without thermal storage capability, the radiator is required to be large enough to release the highest power at the hottest of the heat sink. By engaging and integrating phase-change materials (PCMs) into a passive two-phase heat exchanger, the radiator can be designed and sized for the average rather than the maximum power. To meet the NASA needs, the prototype developed and fabricated in the present study is a novel two-phase heat exchanger that integrates PCMs within a vapor chamber through multiple thin drawers loaded with bulk PCM. The entire solid structure of the prototype is manufactured additively using Maraging Steel with the Direct Laser Metal Sintering (DLMS) technique. The chosen working fluid is Methanol to undertake two-phase heat transfer via saturated vapor from the heated surface of evaporator to the condenser surface, and the condensate then returns back to the heated region and keeps recirculated using the capillary pumping pressure performed by the wick structure without any reliance on the gravitational magnitudes. Depending on the heat sink temperature and PCM melting temperature, the developed heat exchanger can either function as a thermal capacitor or a two-phase heat exchanger with thermal storage capability, that is, two modes of operation to be engaged within the spacecraft's launching/landing stages or orbiting stage, respectively. In the present study, the geometry and number of the PCM-loaded drawers enclosed inside the heat exchanger's casing are optimized based on the mass ratio (the ratio of PCM mass to the total heat exchanger mass), additive manufacturing (AM) constraints, and total thermal resistances imposed on the system for either of the operation modes. The AM printed prototype with its all components are also represented along with technical drawings and specifications. Furthermore, the support structure model generated for metal printing of the proposed heat exchanger will be exposed and discussed. The wick structure design procedure is also presented and its main performance characteristics (e.g., effective pore size, effective thermal conductivity, porosity, and permeability) are reported to analytically examine the capillary pumping limit for the proposed heat exchanger.