...
首页> 外文期刊>International Journal of Heat and Mass Transfer >Simultaneous measurement of interdiffusion and intrinsic diffusion coefficients in liquid metals on the ground
【24h】

Simultaneous measurement of interdiffusion and intrinsic diffusion coefficients in liquid metals on the ground

机译:同时测量地面上液态金属的互扩散和本征扩散系数

获取原文
获取原文并翻译 | 示例
           

摘要

Simultaneous measurements of interdiffusion and intrinsic diffusion coefficients in liquid Sn-Pb were performed using the shear cell method and a stable density layering. The binary diffusion couples of Sn-Pb and Sn0.6Pb0.4-Sn0.4Pb0.6 were used in two experiments with the average molar fraction of diffusion couples N-sn = 0.5. The concentration dependency of the interdiffusion coefficient was confirmed to exhibit a downward convexity through the comparison of the interdiffusion coefficients. However, the Boltzmann-Matano method reveals a diminished influence. The sample measurements of the intrinsic diffusion coefficients of a diffusion couple of pure metals demonstrate a dependency on concentration. On the other hand, the difference of diffusion coefficients was small in a diffusion couple of alloys. The difference between the values calculated by fitting the error function based on the superposition of fluxes and by the conventional analysis methods was small. We propose that a reasonable intrinsic diffusion coefficient can be calculated using the superposed equation of error function. The theoretical interdiffusion coefficients were calculated by substituting the measured intrinsic diffusion coefficients into the Darken's equation and comparing the results with the measured values. As a result, the difference between the theoretical and measured interdiffusion coefficients is not very large. (C) 2018 Elsevier Ltd. All rights reserved.
机译:使用剪切池法和稳定的密度分层法同时测量了液态Sn-Pb中的互扩散系数和本征扩散系数。在两个实验中使用了Sn-Pb和Sn0.6Pb0.4-Sn0.4Pb0.6的二元扩散偶,扩散偶的平均摩尔分数N-sn = 0.5。通过相互扩散系数的比较,证实了相互扩散系数的浓度依赖性显示出向下的凸度。但是,玻耳兹曼-马塔诺方法的影响却减小了。纯金属扩散对的本征扩散系数的样品测量结果证明了对浓度的依赖性。另一方面,在合金的扩散对中扩散系数的差很小。通过基于通量的叠加来拟合误差函数和通过常规分析方法计算出的值之间的差异很小。我们建议可以使用误差函数的叠加方程来计算合理的固有扩散系数。通过将测得的本征扩散系数代入Darken方程,并将结果与​​测得值进行比较,可以计算出理论互扩散系数。结果,理论和测量的互扩散系数之间的差异不是很大。 (C)2018 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号