首页> 外文期刊>International Journal of Heat and Fluid Flow >Gas-liquid flow of sub-millimeter bubbles at low void fractions: Experimental study of bubble size distribution and void fraction
【24h】

Gas-liquid flow of sub-millimeter bubbles at low void fractions: Experimental study of bubble size distribution and void fraction

机译:低空隙率下亚毫米气泡的气液流动:气泡尺寸分布和空隙率的实验研究

获取原文
获取原文并翻译 | 示例
       

摘要

This work studies gas-liquid flow of small bubbles (1 mm) at low void fractions (10(-1)) that is encountered in human bloodstream during Decompression Sickness and is also relevant to two-phase applications such as flow boiling in macro-channels. Two fundamental parameters are experimentally investigated: Bubble Size Distribution (BSD) and void fraction. Experiments are conducted in co-current upward bubbly flow. Water and blood simulant are used as test liquids, while bubble size is controlled using prescribed surfactant (SDS) concentrations. BSDs are determined employing digital image analysis of bubbly flow images captured at three radial positions across the flow cross-section. Volumetric and cross-sectional area averaged void fraction is measured at three axial locations along the flow by Differential Pressure (Delta P) and Electrical Resistance Tomography (ERT), respectively. BSDs are well-fitted by the log-normal distribution. ERT and AP measurements are in fair agreement, with void fraction being practically equal along the flow. The influence of gas/liquid phase velocities and surfactant concentration on the measured void fraction and BSDs' average value and width is discussed in detail. Interestingly, high SDS concentration in blood simulant results in the formation of bubble clusters, whose role on the examined parameters is investigated.
机译:这项工作研究了在减压病期间在人类血液中遇到的低空隙率(<10(-1))的小气泡(<1 mm)的气液流动,并且还与两相应用有关,例如宏渠道。实验研究了两个基本参数:气泡尺寸分布(BSD)和空隙率。实验是在并流向上的气泡流中进行的。将水和血液模拟物用作测试液体,同时使用规定的表面活性剂(SDS)浓度控制气泡大小。通过对在整个流动横截面的三个径向位​​置处捕获的气泡流动图像进行数字图像分析来确定BSD。沿流的三个轴向位置分别通过压差(Delta P)和电阻层析成像(ERT)测量体积和横截面积的平均空隙率。 BSD非常适合对数正态分布。 ERT和AP的测量值基本吻合,沿流的空隙率几乎相等。详细讨论了气相/液相速度和表面活性剂浓度对测得的空隙率和BSD的平均值和宽度的影响。有趣的是,血液模拟物中的高SDS浓度导致气泡簇的形成,并研究了气泡簇对所检查参数的作用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号