首页> 外文期刊>IEICE Transactions on Electronics >A Low-Power IF Circuit with 5 dB Minimum Input SNR for GFSK Low-IF Receivers
【24h】

A Low-Power IF Circuit with 5 dB Minimum Input SNR for GFSK Low-IF Receivers

机译:适用于GFSK低中频接收器的最低输入SNR为5dB的低功率中频电路

获取原文
获取原文并翻译 | 示例
       

摘要

A low-power low-noise intermediate-frequency (IF) circuit is proposed for Gaussian frequency shift keying (GFSK) low-IF receivers. The proposed IF circuit is realized by an all-analog architecture composed of a couple of limiting amplifiers (LAs) and received signal strength indicators (RSSIs), a couple of band-pass filters (BPFs), a frequency detector (FD), a low-pass filter (LPF) and a slicer. The LA and RSSI are realized by an optimized combination of folded amplifiers and current subtracter based rectifiers to avoid the process induced depressing on accuracy. In addition, taking into account the nonlinearity and static current of rectifiers, we propose an analytical model as an accurate approximation of RSSIs' transfer character. An active-RC based GFSK demodulation scheme is proposed, and then both low power consumption and a large dynamic range are obtained. The chip is implemented with HJTC 0.18μm CMOS technology and measured under an intermediate frequency of 200 kHz, a data rate of 100 kb/s and a modulation index of 1. The RSSI has a dynamic range of 51 dB with a logarithmic linearity error of less than ± 1 dB, and the slope is 23.9 mV/dB. For 0.1 % bit error ratio (BER), the proposed IF circuit has the minimum input signal-to-noise ratio (SNR) of 5 dB and an input dynamic range of 55.4 dB, whereas it can tolerate a frequency offset of -3%~+9.5% at 6 dB input SNR. The total power consumption is 5.65-5.89 mW.
机译:提出了一种用于高斯频移键控(GFSK)低中频接收机的低功耗低噪声中频(IF)电路。拟议的IF电路是由全模拟架构实现的,该架构由几个限幅放大器(LA)和接收信号强度指示器(RSSI),两个带通滤波器(BPF),一个频率检测器(FD),一个低通滤波器(LPF)和限幅器。通过折叠放大器和基于电流减法器的整流器的优化组合来实现LA和RSSI,以避免过程引起的精度降低。此外,考虑到整流器的非线性和静态电流,我们提出了一个解析模型,作为RSSI传递特性的精确近似。提出了一种基于有源RC的GFSK解调方案,从而获得了低功耗和大动态范围。该芯片采用HJTC0.18μmCMOS技术实现,在200 kHz的中频,100 kb / s的数据速率和1的调制指数下进行测量。RSSI的动态范围为51 dB,对数线性误差为小于±1 dB,且斜率为23.9 mV / dB。对于0.1%的误码率(BER),建议的IF电路具有5 dB的最小输入信噪比(SNR)和55.4 dB的输入动态范围,而它可以容忍-3%的频率偏移在6 dB输入SNR时约为+ 9.5%。总功耗为5.65-5.89 mW。

著录项

  • 来源
    《IEICE Transactions on Electronics》 |2011年第10期|p.1680-1689|共10页
  • 作者单位

    The authors are with the TNLIST and Department of Electronic Engineering, Tsinghua University, Beijing, 100084, P.R. China;

    The authors are with the TNLIST and Department of Electronic Engineering, Tsinghua University, Beijing, 100084, P.R. China;

    The authors are with the TNLIST and Department of Electronic Engineering, Tsinghua University, Beijing, 100084, P.R. China;

    The authors are with the TNLIST and Department of Electronic Engineering, Tsinghua University, Beijing, 100084, P.R. China;

    The authors are with the TNLIST and Department of Electronic Engineering, Tsinghua University, Beijing, 100084, P.R. China;

    The authors are with the TNLIST and Department of Electronic Engineering, Tsinghua University, Beijing, 100084, P.R. China;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    limiting amplifier (la); received signal strength indicator (rssi); demodulator; slicer;

    机译:限幅放大器(la);接收信号强度指示器(RSSI);解调器切片机;
  • 入库时间 2022-08-18 00:26:47

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号