首页> 外文期刊>電子情報通信学会技術研究報告 >位相中心位置を考慮したダブルリッジガイドホーンアンテナの利得の決定
【24h】

位相中心位置を考慮したダブルリッジガイドホーンアンテナの利得の決定

机译:考虑相位中心位置的双脊导喇叭天线增益的确定

获取原文
获取原文并翻译 | 示例
       

摘要

1GHz以上のEMI測定に使用するアンテナの校正は、一般に、自由空間での3アンテナ法を用いて行われる。開口面アンテナを校正するとき、3アンテナ法に基づくアンテナ間距離として、開口面間距離がよく用いられる。ダブルリッジガイドホーンアンテナの位相中心を有限積分法により推定し、位相中心間距離を用いてアンテナ利得を決定した。位相中心位置を考慮して求めた利得の測定結果は理論値とよく一致した。%EMI antennas used above 1GHz are generally calibrated in an anechoic chamber using the three-antenna method. The distance between antenna apertures is often used for aperture antennas as the antenna separation distance based on the three-antenna method. In this paper, the phase center location is used to determine the gain for double-ridge guide horn antennas. The phase center of a ridge horn antenna is calculated using the finite integral method, and then the gain is measured by using the distance between phase centers obtained from this calculation. Measured results of gain on the basis of phase center locations are in good agreement with theoretical values.
机译:通常,在自由空间中使用三天线方法对用于1 GHz以上EMI测量的天线进行校准。校准孔径平面天线时,通常将孔径平面之间的距离用作基于3天线方法的天线间距离。通过有限积分法估计了双脊形导向喇叭天线的相位中心,并利用相位中心之间的距离确定了天线增益。通过考虑相位中心位置获得的增益的测量结果与理论值非常吻合。 1 GHz以上使用的EMI天线百分比通常在三腔法消声室内进行校准,孔径天线之间的距离通常用作孔径天线,这是基于三天线方法的天线间隔距离。中心位置用于确定双脊形引导喇叭天线的增益。使用有限积分法计算脊形喇叭天线的相位中心,然后使用从该计算获得的相位中心之间的距离来测量增益。基于相位中心位置的增益测量结果与理论值非常吻合。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号