Simulations of CO2 injection into fractures and faults for improving their geophysical characterization at EGS sites

摘要

We propose the use of CO2 in push-pull well tests to improve geophysical identification and characterization of fractures and faults at enhanced geothermal system (EGS) sites. Using TOUGH2/ECO2N, we carried out numerical experiments of push-pull injection-production cycling of CO2 into idealized vertical fractures and faults to produce pressure-saturation-temperature conditions that can be analyzed for their geophysical response. Our results show that there is a strong difference between injection and production mainly because of CO2 buoyancy. While the CO2-plume grows laterally and upward during injection, not all CO2 is recovered during the subsequent production phase. Even under the best conditions for recovery, at least 10% of the volume of the pores still remains filled with CO2. To improve EGS characterization, comparisons can be made of active seismic methods carried out before and after (time lapse mode) CO2 injection into the fracture or fault. We find that across the CO2 saturation range, C-11 (the normal stiffness in the horizontal direction perpendicular to the fracture plane) varies between maximum and minimum values by about 15%. It reaches a maximum at around 6% gas saturation, decreasing exponentially to a minimum at higher saturations. Our results suggest that CO2 injection can be effectively used to infiltrate fault and fracture zones reaching about optimal saturation values in order to enhance seismic imaging at EGS sites.