...
首页> 外文期刊>Geotechnique >Influence of initial stress distribution on liquefaction-induced settlement of shallow foundations
【24h】

Influence of initial stress distribution on liquefaction-induced settlement of shallow foundations

机译:初始应力分布对液化引起浅层基础沉降的影响

获取原文
获取原文并翻译 | 示例
           

摘要

During earthquakes, saturated sandy soils may generate significant excess pore pressures and approach a state of liquefaction. Structures founded on shallow foundations above such soils may consequently undergo large settlements. Recent case history analysis has shown that the stress imposed by the foundation is a key factor in the estimation of such settlements. However, the case history data showed that although increasing bearing pressure caused an increase in settlements as expected, this was only true up to a point, and that very heavy structures appeared to settle less than some lighter structures. This work aims to investigate these counter-intuitive results by means of controlled experimental testing using a geotechnical centrifuge. Results of the centrifuge tests show that the trend derived from case histories is correct and that liquefaction-induced settlements peak for a given bearing stress (90 kPa for the models tested) and reduce for greater applied stresses. Further, by analysis of excess pore pressure distributions beneath the foundations it is shown that the main factor inhibiting pore pressure generation beneath the footings is not so much the confining pressure as the in-situ static shear stress around the edge of the foundation. This is supported by element test data from the literature. When this initial static shear stress is so high that the applied cyclic shear stress cannot exceed it (i.e. the direction of shear stress does not reverse) then pore pressure generation is greatly reduced, thus causing the observed reduction in expected settlements.
机译:在地震期间,饱和的沙质土壤可能会产生明显的孔隙压力,并接近液化状态。因此,在此类土壤之上的浅层基础上建立的结构可能会经历较大的沉降。最近的案例历史分析表明,基金会施加的压力是估算此类解决方案的关键因素。但是,案例历史记录数据显示,尽管承压增加导致沉降增加,但仅在一定程度上是正确的,非常重的结构沉降的程度似乎小于某些较轻的结构。这项工作旨在通过岩土离心机进行的受控实验测试来调查这些违反直觉的结果。离心测试的结果表明,从案例历史中得出的趋势是正确的,并且在给定的轴承应力(对于测试的模型为90 kPa)下,液化引起的沉降达到峰值,并在更大的施加应力下降低。此外,通过分析地基下方多余的孔隙压力分布,可以看出,抑制基础下方孔隙压力产生的主要因素不是围压,而是地基边缘周围的原地静态切应力。文献中的元素测试数据对此提供了支持。当该初始静态剪应力如此之高以至于所施加的循环剪应力不能超过它时(即剪应力的方向不会反向),则孔隙压力的产生会大大减少,从而导致观察到的预期沉降量的减少。

著录项

  • 来源
    《Geotechnique》 |2015年第5期|418-428|共11页
  • 作者

    Bertalot D.; Brennan A. J.;

  • 作者单位

    DAppolonia SpA, Genoa, Italy|Univ Dundee, Dept Civil Engn, Dundee DD1 4HN, Scotland;

    Univ Dundee, Dept Civil Engn, Dundee DD1 4HN, Scotland;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    centrifuge modelling; footings/foundations; liquefaction;

    机译:离心机模型;基础/基础;液化;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号