ITER Vacuum Vessel design and construction

摘要

After implementing a few design modifications (referred to as the "Modified Reference Design") in 2009, the Vacuum Vessel (W) design had been stabilized. The W design is being finalized, including interface components such as support rails and feedthroughs for the in-vessel coils. It is necessary to make adjustments to the locations of the blanket supports and manifolds to accommodate design modifications to the in-vessel coils. The W support design is also being finalized considering a structural simplification. Design of the in-wall shielding (IWS) has progressed, considering the assembly methods and the required tolerances. The detailed layout of ferritic steel plates and borated steel plates was optimized based on the toroidal field ripple analysis. A dynamic test on the inter-modular key to support the blanket modules was performed to measure the dynamic amplification factor (DAF). An R&D program has started to select and qualify the welding and cutting processes for the port flange lip seal. The 1TER W material 316 L(N) 1G was already qualified and the Modified Reference Design was approved by the Agreed Notified Body (ANB) in accordance with the Nuclear Pressure Equipment Order procedure.