...
首页> 外文期刊>Fuel >Optimisation of NO_x reduction in advanced coal reburning systems and the effect of coal
【24h】

Optimisation of NO_x reduction in advanced coal reburning systems and the effect of coal

机译:先进燃煤再燃系统中NO_x还原的优化及燃煤效果

获取原文
获取原文并翻译 | 示例
           

摘要

The advanced reburning process for NO_x emission control was studied in a down-fired 20 kW combustor by evaluating the performance of 15 pulverised coals as reburning fuels. The proximate volatile matter contents of the coals selected ranged from around 4 to 40 wt% (as received) with elemental nitrogen contents from around 0.6 to 2.0 wt%. The effects of reburn fuel fraction, reburning zone residence time, ammonia agent injection delay time (relative to the reburn fuel and burnout air injection points) and the nitrogen stoichiometric ratio are reported in detail and the optimum configurations for advanced reburning, established as a function of operating condition and coal type. The experimental results show that advanced reburning can reduce NO_x emissions up to 85%. The maximum benefits of advanced reburning over conventional reburning were observed at the lower reburn fuel fractions (around 10%). The results demonstrate that under advanced reburning conditions equivalent or higher levels of NO_x reduction can be achieved while operating the reburn zone closer to stoichiometric conditions compared with conventional reburning operating at high reburn fuel fractions (20-25%). Thus the practical problems associated with fuel-rich staged operation can be reduced. The effect of coal properties on the advanced reburning performance was also investigated. As with conventional reburning, the fuel nitrogen content of the coal used was found to have little influence on the NO_x reduction efficiency except at the highest reburn fuel fractions. There was, however, a strong correlation between the effectiveness of advanced reburning and the volatile content of the reburning fuels, which not only depended on the reburn fuel fraction, but also the mode (rich or lean) of advanced reburning operation. These parameters are mapped out experimentally to enable the best operating mode to be selected for advanced reburning as a function of the reburning fuel fraction and volatile content.
机译:通过评估15种煤粉作为再燃燃料的性能,在20千瓦向下燃烧的燃烧室中研究了用于控制NO_x排放的先进再燃过程。所选择的煤的最接近挥发物含量为约4至40重量%(原样),元素氮含量为约0.6至2.0重量%。详细报告了再燃燃料分数,再燃区停留时间,氨气喷射延迟时间(相对于再燃燃料和燃尽空气喷射点)和氮化学计量比的影响,并根据功能确定了先进再燃的最佳配置工作条件和煤类型实验结果表明,先进的再燃烧可以减少高达85%的NO_x排放。在较低的再燃燃料分数(约10%)下,可以观察到先进再燃相对于传统再燃的最大好处。结果表明,与在高再燃燃料分数(20-25%)下运行的常规再燃相比,在更接近化学计量条件的条件下运行再燃区时,在先进的再燃条件下可以实现等同或更高水平的NO_x还原。因此,可以减少与富燃料分级运行相关的实际问题。还研究了煤性质对先进再燃性能的影响。与常规再燃烧一样,发现所用煤的燃料氮含量对NO_x还原效率的影响很小,除了在最高再燃烧燃料分数下。然而,高级再燃烧的效果与再燃烧燃料的挥发性含量之间存在很强的相关性,这不仅取决于再燃烧燃料的比例,还取决于先进再燃烧操作的方式(浓或稀)。这些参数通过实验进行映射,以便根据再燃燃料分数和挥发物含量,选择最佳操作模式进行高级再燃。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号