Technical applicability of low-swirl fuel nozzle for liquid-fueled industrial gas turbine combustor

摘要

In this study, potentials of the liquid-fueled low-swirl burner technique for industrial gas-turbine combustor application are reported for the first time. A low-swirl fuel nozzle, which is a new implementation of the basic low-swirl burner design, is configured by the velocity measurement of methane-air open flames under atmospheric pressure and a low velocity (~3 m/s) condition. Flow properties, such as the axial stretch rate and virtual origins, are compared with the previously reported values with the axial vane type low-swirl injector, and it is confirmed that the flow field generated from the current implementation is of the typical low-swirl flow. Then, it is shown that the configuration successfully stabilize the lifted flame under much higher velocity (~50 m/s) condition with kerosene fuel injected by a typical pressure atomizer. Finally, the fuel nozzle is installed in a 290 kW simple-cycle liquid-fueled gas turbine engine and is found to be operable over the entire operating range. The combustor inlet wall temperatures are shown to be within an acceptable range, even without the cooling air that was required for conventional combustors. This is an advantage of the lifted flame stabilized by the low-swirl technique. Although our focus is not on low emissions characteristics, NOx emissions is also found to be below maximum levels of current Japanese regulations (<84 ppm@15% O_2). In sum, the proposed fuel nozzle design shows promise for the application of liquid-fueled industrial gas turbine engines.