首页> 外文期刊>Fuel >Multiple optical diagnostics on effect of fuel stratification degree on reactivity controlled compression ignition
【24h】

Multiple optical diagnostics on effect of fuel stratification degree on reactivity controlled compression ignition

机译:燃料分层度对反应性受控压燃影响的多重光学诊断

获取原文
获取原文并翻译 | 示例
           

摘要

Reactivity controlled compression ignition (RCCI) was investigated on a light-duty optical engine under different fuel stratification degrees, using multiple laser diagnostic techniques. The engine was run at a speed of 1200 rpm and under a load of about 7 bar gross IMEP. To form different fuel stratification degrees, the direct-injection timings of n-heptane were changed, while the port-injection timings of iso-octane was kept constant. The fuel/air equivalence ratio and primary reference fuel (PRF) number were quantified by the fuel-tracer planar laser-induced fluorescence (PLIF) under non-combusting condition. The results indicated that with retarding n-heptane injection timing from -90 degrees CA ATDC (RCCI-90 case) to -10 degrees CA ATDC (RCCI-10 case), regions of higher fuel concentration and reactivity moved downstream to the edge of combustion chamber before high-temperature heat release (HTHR) phase. Timeresolved natural combustion luminosity imaging and single-shot OH PLIF imaging indicated that RCCI-10 case presented a staged combustion process that an auto-ignition first happened in the region of high reactivity around the combustion chamber and then another auto-ignition process took place in the region of low reactivity in the central part of the combustion chamber. The staged combustion feature involved in RCCI combustion could result in lower combustion pressure-rise rate. PLIF images of formaldehyde showed that formaldehyde first formed during low-temperature heat release (LTHR) phase in the regions where n-heptane resided. With retarding n-heptane injection timings, both formaldehyde and OH PLIF images presented more stratified distribution, and the consumption of formaldehyde and formation of OH processes got slower. OH PLIF images indicated that HTHR phase of RCCI could extend to the central part of combustion chamber. In the low-load LTC conceptual model proposed by Musculus et al. (2013), no HTHR happened and UHC formed in the central part of combustion chamber. This meant that RCCI could have less UHC emission than LTC in theory. (C) 2017 Elsevier Ltd. All rights reserved.
机译:使用多种激光诊断技术,在轻型光学发动机上以不同的燃料分层度研究了反应性控制的压缩点火(RCCI)。发动机以1200 rpm的速度和大约7 bar的总IMEP负荷运行。为了形成不同的燃料分层度,改变了正庚烷的直接喷射正时,而异辛烷的端口喷射正时保持恒定。在不燃烧条件下,通过燃料示踪剂平面激光诱导的荧光(PLIF)定量确定燃料/空气当量比和一次参考燃料(PRF)数量。结果表明,随着正庚烷喷射时间从-90度CA ATDC(RCCI-90情况)延迟到-10度CA ATDC(RCCI-10情况),较高燃料浓度和反应性的区域向下游移动到燃烧边缘高温放热(HTHR)相之前的加热室。时间分辨自然燃烧发光度成像和单次OH PLIF成像表明RCCI-10案例呈现了一个分阶段的燃烧过程,自燃首先发生在燃烧室周围的高反应性区域,然后在燃烧室中发生了另一个自燃过程。在燃烧室中央的低反应性区域。 RCCI燃烧涉及的分级燃烧特征可能导致较低的燃烧压力上升速率。甲醛的PLIF图像显示甲醛是在正庚烷所在的区域中的低温放热(LTHR)相期间首先形成的。随着正庚烷进样时间的延迟,甲醛和OH PLIF图像均呈现出更分层的分布,甲醛的消耗和OH过程的形成变慢。 OH PLIF图像表明RCCI的HTHR相可以延伸到燃烧室的中心部分。在Musculus等人提出的低负载LTC概念模型中。 (2013年),没有HTHR发生,UHC在燃烧室的中心部分形成。从理论上讲,这意味着RCCI的UHC排放量可能少于LTC。 (C)2017 Elsevier Ltd.保留所有权利。

著录项

  • 来源
    《Fuel》 |2017年第15期|688-698|共11页
  • 作者单位

    Tianjin Univ, State Key Lab Engines, Tianjin 300072, Peoples R China;

    Tianjin Univ, State Key Lab Engines, Tianjin 300072, Peoples R China;

    Tianjin Univ, State Key Lab Engines, Tianjin 300072, Peoples R China;

    Tianjin Univ, State Key Lab Engines, Tianjin 300072, Peoples R China;

    Tianjin Univ, State Key Lab Engines, Tianjin 300072, Peoples R China;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    RCCI; Fuel stratification degree; Optical diagnostics; PLIF;

    机译:RCCI;燃料分层度;光学诊断;PLIF;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号