首页> 外文期刊>Fuel >Experimental study on the dynamic filtration control performance of N-2/liquid CO2 foam in porous media
【24h】

Experimental study on the dynamic filtration control performance of N-2/liquid CO2 foam in porous media

机译:N-2 /液态CO2泡沫在多孔介质中动态过滤控制性能的实验研究

获取原文
获取原文并翻译 | 示例
           

摘要

Liquid CO2 has been successfully used as a fracturing fluid and injected into rock formations to enhance oil and gas production. However, the difficulty in controlling the filtration of liquid CO2 in porous media limits its application. The goal of this study is to investigate the dynamic filtration control performance of N-2/liquid CO2 foam with a fluorochemical (HFE) as stabilizer. A laboratory apparatus has been specially designed and built for the generation of N-2/liquid CO2 foams and the measurement of their viscosity and filtration rate under high pressure (10-25 MPa). The test results show that after liquid CO2 and HFE were mixed with N-2, the N-2/liquid CO2 foams were generated and showed significant viscosity improvement compared to liquid CO2. The foams exhibited better filtration control performance compared to liquid CO2 and liquid CO2 + N-2 systems. Although the addition of HFE did not result in the formation of filter cake, the foam showed a wall-building behavior, which could be explained by the CO2 phase change in porous media. As foam quality increased from 28% to 92%, the leakoff coefficient and spurt loss volume first decreased until the foam became unstable and changed into mist flow. The leakoff coefficient of foam increased with the increase in permeability of porous media. For foam with the quality of about 50-80%, a change of 2 orders of magnitude in permeability resulted in a change of 1 order of magnitude in leakoff coefficient. At high pressure difference, lower initial quality foam (similar to 30%) showed better filtration performance than higher initial quality foam (similar to 80%). When the pressure difference was high enough to cause the CO2 phase change from liquid to gas in the porous media, the initial foam damage after filtration became obvious, but the damage could be eliminated with time by gas return flow. Thus, by using N2/liquid CO2 foam in porous media, the fluid filtration behavior could be controlled without damage. (C) 2017 Elsevier Ltd. All rights reserved.
机译:液态二氧化碳已成功用作压裂液,并已注入岩层,以提高油气产量。但是,控制多孔介质中液态CO2过滤的困难限制了它的应用。这项研究的目的是研究以氟化物(HFE)为稳定剂的N-2 /液态CO2泡沫的动态过滤控制性能。已经专门设计并制造了一种实验室设备,用于生成N-2 /液态CO2泡沫,并在高压(10-25 MPa)下测量其粘度和过滤速率。测试结果表明,将液态CO2和HFE与N-2混合后,会生成N-2 /液态CO2泡沫,与液态CO2相比,粘度显着提高。与液态CO2和液态CO2 + N-2系统相比,泡沫具有更好的过滤控制性能。尽管加入HFE不会导致滤饼的形成,但泡沫塑料显示出了建墙行为,这可以用多孔介质中的CO2相变来解释。当泡沫质量从28%增加到92%时,泄漏系数和喷射损失量首先减小,直到泡沫变得不稳定并变成雾状流动为止。泡沫的泄漏系数随多孔介质渗透率的增加而增加。对于质量约为50-80%的泡沫,渗透率变化2个数量级会导致泄漏系数变化1个数量级。在高压差下,较低质量的初始泡沫(约30%)显示出比较高质量的初始泡沫(约80%)更好的过滤性能。当压力差高到足以引起多孔介质中CO2相从液体变为气体时,过滤后的初始泡沫破坏变得明显,但随着时间的流逝,气体回流可以消除这种破坏。因此,通过在多孔介质中使用N2 /液态CO2泡沫,可以控制流体过滤行为而不会造成损坏。 (C)2017 Elsevier Ltd.保留所有权利。

著录项

  • 来源
    《Fuel》 |2017年第15期|435-445|共11页
  • 作者单位

    China Univ Petr, Coll Petr Engn, Qingdao 266580, Shandong, Peoples R China;

    China Univ Petr, Coll Petr Engn, Qingdao 266580, Shandong, Peoples R China;

    China Univ Petr, Coll Petr Engn, Qingdao 266580, Shandong, Peoples R China;

    China Univ Petr, Coll Petr Engn, Qingdao 266580, Shandong, Peoples R China;

    China Univ Petr, Coll Petr Engn, Qingdao 266580, Shandong, Peoples R China;

    China Univ Petr, Coll Petr Engn, Qingdao 266580, Shandong, Peoples R China;

    China Univ Petr, Coll Petr Engn, Qingdao 266580, Shandong, Peoples R China;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    Dynamic filtration; N-2; Liquid CO2; Foam; Porous media;

    机译:动态过滤N-2液态CO2泡沫多孔介质;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号