...
首页> 外文期刊>Energy & fuels >Formation of Submicron Particulates (PM_1) from the Oxygen-Enriched Combustion of Dried Sewage Sludge and Their Properties
【24h】

Formation of Submicron Particulates (PM_1) from the Oxygen-Enriched Combustion of Dried Sewage Sludge and Their Properties

机译:干污泥富氧燃烧形成亚微米颗粒(PM_1)及其性能

获取原文
获取原文并翻译 | 示例
           

摘要

The dried sewage sludges were pulverized and combusted in an oxygen-enriched atmosphere to investigate the emission of particulate matter smaller than 1.0 μm (PM_1). Combustions were conducted at 1200℃ in a drop tube furnace with the oxygen content varying from 10% to 30% and 50% in the gas atmosphere. The collected PM_1 was characterized including its concentration, particle size distribution, and the size-dependence of the elemental composition and chemical species. The results indicate that, after the complete combustion of sludges, the PM_1 formed accounts for about 1~7% on the basis of total ash, which is influenced significantly by the oxygen content in the gas atmosphere as well as the sludge type. In general, because of the improvement on the temperature of char particles and their breakage, the amount of PM_1 is increased exponentially with the increasing of the oxygen content. With regard to PM_1 formation mechanisms, the refractory elements within it, including Si, Al, Ca, Fe, and Mg, undergo two pathways for their transformation: vaporization—condensation for their presence in the particulates ≤ 0.1 μm (PM_(0.1)) and direct liberation of the inherent fine minerals for their presence in those > 0.1 μm. Their modes of occurrence in raw sludge play an important role in the vaporization. At 10% oxygen content, decomposition of the organically bound fraction is the main way contributing to their presence in PM_(0.1). With the oxygen content increases, more of the inorganic species vaporizes too. Direct liberation of the refractory metals is also determined positively by the oxygen content in the gas atmosphere, which is due to the breakage of char particles at an elevated oxygen content. With regard to the volatile elements in PM_1, including P, S, Na, K, Zn, Cl, and Mn, they were mainly generated by the vaporization—condensation mechanism. Vaporization of S, Cl, Na, and K is significantly obvious at 10% oxygen, and hence, sulfates and chlorides are favored. With the oxygen content increases, the vaporization of P and Zn becomes significant. The amounts of Na and K are almost unchanged; meanwhile, S and Cl decrease somewhat. Formation of the phosphates is facilitated, owing to the high partial pressure of P. A portion of Na and K is possibly captured by Al silicates. Zn is also possibly captured by apatite and iron oxide to form the complex compounds. The toxicity of these species needs a detailed evaluation.
机译:将干燥的污水污泥粉碎并在富氧气氛中燃烧,以研究小于1.0μm(PM_1)的颗粒物的排放。在滴管炉中于1200℃进行燃烧,在气体气氛中,氧含量在10%至30%和50%之间变化。收集到的PM_1的特征包括其浓度,粒径分布以及元素组成和化学物质的尺寸依赖性。结果表明,污泥完全燃烧后,形成的PM_1约占总灰分的1〜7%,这主要受气体气氛中氧含量和污泥类型的影响。通常,由于炭颗粒温度的提高和它们的破裂,随着氧含量的增加,PM_1的含量呈指数增加。关于PM_1的形成机理,其中的难熔元素(包括Si,Al,Ca,Fe和Mg)经历了两种转化途径:汽化-由于存在于≤0.1μm的颗粒中而凝结(PM_(0.1))并直接释放固有的精细矿物质,使其存在> 0.1μm。它们在原始污泥中的发生方式在汽化中起重要作用。氧含量为10%时,有机键合部分的分解是导致其存在于PM_(0.1)中的主要方法。随着氧含量的增加,更多的无机物也会蒸发。难熔金属的直接释放还取决于气体气氛中的氧气含量,这是由于炭颗粒在较高的氧气含量下破裂而导致的。关于PM_1中的挥发性元素,包括P,S,Na,K,Zn,Cl和Mn,它们主要是通过汽化-冷凝机制产生的。在10%的氧气下,S,Cl,Na和K的汽化作用非常明显,因此,硫酸盐和氯化物受到青睐。随着氧含量的增加,P和Zn的汽化变得明显。 Na和K的含量几乎没有变化。同时,S和Cl有所降低。由于P的高分压,磷酸盐的形成变得容易。一部分Na和K可能被Al硅酸盐捕获。锌也可能被磷灰石和氧化铁捕获而形成络合物。这些物质的毒性需要详细评估。

著录项

  • 来源
    《Energy & fuels》 |2007年第1期|p.88-98|共11页
  • 作者单位

    Department of Applied Chemistry, College of Engineering, Chubu University, Matsumoto-cho, 1200, Kasugai, Aichi 487-8501, Japan;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);美国《生物学医学文摘》(MEDLINE);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类 TK-;
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号