首页> 外文期刊>Energy & fuels >Novel Simplification Approach for Large-Scale Structural Models of Coal: Three-Dimensional Molecules to Two-Dimensional Lattices. Part 3: Reactive Lattice Simulations
【24h】

Novel Simplification Approach for Large-Scale Structural Models of Coal: Three-Dimensional Molecules to Two-Dimensional Lattices. Part 3: Reactive Lattice Simulations

机译:煤的大规模结构模型的新型简化方法:从三维分子到二维晶格。第3部分:反应格模拟

获取原文
获取原文并翻译 | 示例
       

摘要

Various stuthes have used lattice structures combined with simplistic kinetics to explore the devolatilization of coal with the goal of predicting yields of gas, tar, and char. In our previous work, we have demonstrated the ability to reduce a three-dimensional (3D) large-scale (>50 000 atoms) atomistic representation of Illinois no. 6 bituminous coal to a coal-specific two-dimensional (2D) lattice with cross-links being depicted as linkage lines and aromatic clusters being depicted as nodes. Because there is a direct link between the full complexity of the atomistic representation and the 2D lattice, the cross-links within the coal topography can be identified. Using this structural information, a statistical simulation of the kinetically controlled liquefaction reactions of an Illinois no. 6 coal lattice was performed. The Illinois no. 6 coal lattice was composed of a distribution of singular nodes, dimers, and multi-linkage molecules that ranged from 3 nodes (or dusters) to a 16-node entity. Probabilities for the cleavage of coal interunit links were calculated on the basis of the mixture of 10 model compounds comprised of two benzene rings connected by a cross-link (e.g., diphenyl sulfide, benzyl phenyl ether, diphenyl ether, etc.) equivalent to those found in the Illinois no. 6 model. The mixture of model compounds was based on the concentrations of cross-links representative of the model (and, thus, the coal analysis). Cross-link-specific kinetic parameters (Arrhenius pre-exponential factor and activation energy) for each pyrolysis reaction were obtained from literature sources or tuned from composition data using the Kinetic Modeling Editor, a software tool used to generate and solve the balance equations in a kinetic model. At a heating rate of 5 ℃/min, thermolysis calculations from 360 to 490 ℃ showed that the 2D lattice structure broke down extensively, generating mainly monomer cluster molecules. At 400 ℃ with residence times of 600 and 1600 s, the number of cross-links between aromatic units was reduced by 40 and 6096, respectively, from the original population. At higher temperatures, the breakdown of the weaker and more lanetically favored cross-links (-CH_2S- and -OCH_2-) occurred rapidly at the earlier stages of heating. The absolute probability of cleavage (P_i) of certain cross-links (-CH_2CH_2-, -CH_2OCH_2-, etc.) increased at longer residence times. Cross-links such as phenyl and doubly aromatic bound (-S- and -O-) remained essentially unreactive at the conditions explored.
机译:各种储罐使用晶格结构和简单的动力学方法来探索煤的挥发度,目的是预测瓦斯,焦油和焦炭的收率。在我们之前的工作中,我们证明了减少伊利诺伊州立大学3D(3D)大规模(大于5万个原子)原子表示的能力。将6个烟煤转换成特定于煤的二维(2D)晶格,其中将交联描绘为链接线,并将芳香族簇描绘为节点。因为在原子表示的完全复杂性和2D晶格之间存在直接的联系,所以可以确定煤形貌内的交联。使用该结构信息,对伊利诺伊州伊利诺伊州的动力学控制液化反应进行统计模拟。进行6个煤晶格。伊利诺伊州6个煤晶格由奇异节点,二聚体和多链接分子的分布组成,范围从3个节点(或喷粉器)到16个节点实体。基于由两个通过交联连接的两个苯环(例如,二苯硫醚,苄基苯基醚,二苯醚等)组成的10种模型化合物的混合物,计算出了煤内部单元连接的断裂概率。在伊利诺伊州没有找到。 6个型号。模型化合物的混合物基于代表模型的交联浓度(因此也包括煤分析)。每个热解反应的交联特定动力学参数(Arrhenius指数前因子和活化能)可从文献资料中获得,或使用Kinetic Modeling Editor(动力学模型编辑器)从组成数据中进行调整,Kinetic Modeling Editor是一种软件工具,可用于生成和求解平衡方程。动力学模型。以5℃/ min的升温速率,从360到490℃的热解计算表明,二维晶格结构大量破裂,主要生成单体簇分子。在400℃停留时间为600和1600 s时,芳香单元之间的交联数分别比原始种群减少40和6096。在较高的温度下,较弱的和较偏爱的交联键(-CH_2S-和-OCH_2-)的分解在加热的早期阶段迅速发生。在更长的停留时间下,某些交联键(-CH_2CH_2-,-CH_2OCH_2-等)的断裂绝对概率(P_i)增加。在所研究的条件下,诸如苯基和双芳族键(-S-和-O-)之类的交联基团基本上保持不反应。

著录项

  • 来源
    《Energy & fuels》 |2013年第mayajuna期|2915-2922|共8页
  • 作者单位

    John and Willie Leone Family Department of Energy and Mineral Engineering and the Earth and Mineral Sciences (EMS) Energy Institute,The Pennsylvania State University, University Park, Pennsylvania 16802, United States;

    Department of Chemical and Biomolecular Engineering, University of Delaware, Newark, Delaware 19716, United States;

    Department of Chemical and Biomolecular Engineering, University of Delaware, Newark, Delaware 19716, United States;

    The Applied Research Laboratory, The Pennsylvania State University, University Park, Pennsylvania 16802, United States;

    John and Willie Leone Family Department of Energy and Mineral Engineering and the Earth and Mineral Sciences (EMS) Energy Institute,The Pennsylvania State University, University Park, Pennsylvania 16802, United States;

    John and Willie Leone Family Department of Energy and Mineral Engineering and the Earth and Mineral Sciences (EMS) Energy Institute,The Pennsylvania State University, University Park, Pennsylvania 16802, United States;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);美国《生物学医学文摘》(MEDLINE);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号