首页> 外文期刊>Energy Conversion & Management >Investigations into enhanced wax production with combustion synthesized Fischer-Tropsch catalysts
【24h】

Investigations into enhanced wax production with combustion synthesized Fischer-Tropsch catalysts

机译:利用燃烧合成的费-托催化剂提高蜡产量的研究

获取原文
获取原文并翻译 | 示例
           

摘要

Combustion synthesized (CS) cobalt catalysts deposited over two supports, alumina and silica doped alumina (SDA), were characterized and tested for its Fischer-Tropsch (FT) activity. The properties of CS catalysts were compared to catalysts synthesized by conventional impregnation method (IWI). The CS catalysts resulted in 40-70% increase in the yield of C6+ hydrocarbons compared to MI catalysts. The FT activity for CS catalysts showed formation of long chain hydrocarbon waxes (C24+) compared to the formation of middle distillates (C-10-C-20) for IWI synthesized catalysts, indicating higher hydrocarbon chain growth probability for CS catalysts. This is ascribed to the smaller crystallite sizes, increased degree of cobalt reduction and consequentially, a higher number of active metal sites, exposed over the catalyst surface. Additionally, 12-13% increase in the overall C6+ hydrocarbon yield is realized for SDA-CS catalysts, compared to Al2O3-CS catalysts. The improved performance of CS-SDA catalysts is attributed to 48% increase in cobalt dispersion compared to Al2O3 supported CS catalysts, which is again caused by the decrease in the cobalt -support interaction for SDA supports. The metal support interactions were analyzed using XPS and H-2 TPR-TPD experiments. Combustion method produced catalysts with smaller crystallite size (17-18 nm), higher degree of reduction (similar to 92%) and higher metal dispersion (16.1%) compared to the IWI method. Despite its enhanced properties, the CS catalysts require prominently higher reduction temperatures (similar to 1100-1200 K). The hydrocarbon product analysis for Al2O3 supported catalyst showed higher paraffin wax concentrations compared to SDA supported catalysts, due to the lower surface basicity of Al2O3. This work reveals the impact of the CS catalysts and the nature of support on FT activity and hydrocarbon product spectrum. (C) 2016 Elsevier Ltd. All rights reserved.
机译:表征并测试了沉积在两种载体氧化铝和掺杂二氧化硅的氧化铝(SDA)上的燃烧合成(CS)钴催化剂的费-托(FT)活性。将CS催化剂的性能与通过常规浸渍法(IWI)合成的催化剂进行了比较。与MI催化剂相比,CS催化剂使C6 +烃的产率提高了40-70%。与IWI合成催化剂的中间馏出物(C-10-C-20)的形成相比,CS催化剂的FT活性显示出长链烃蜡(C24 +)的形成,表明CS催化剂具有更高的烃链增长可能性。这归因于暴露在催化剂表面上的较小的微晶尺寸,增加的钴还原度以及相应地较高数量的活性金属位点。此外,与Al2O3-CS催化剂相比,SDA-CS催化剂的总C6 +烃产率提高了12-13%。 CS-SDA催化剂性能的提高归因于与Al2O3负载的CS催化剂相比,钴分散度增加了48%,这又是由于SDA载体的钴-载体相互作用降低所致。使用XPS和H-2 TPR-TPD实验分析了金属载体之间的相互作用。与IWI方法相比,燃烧法生产的催化剂具有较小的微晶尺寸(17-18 nm),较高的还原度(大约为92%)和较高的金属分散度(16.1%)。尽管CS催化剂具有增强的性能,但仍需要明显更高的还原温度(类似于1100-1200 K)。 Al2O3负载的催化剂的烃产物分析显示,与SDA负载的催化剂相比,石蜡的浓度更高,这是因为Al2O3的表面碱度较低。这项工作揭示了CS催化剂的影响以及载体性质对FT活性和烃产物谱的影响。 (C)2016 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号