A method for detecting the transition from corona from water droplets to dry-band arcing on silicone rubber insulators

摘要

The paper presents an investigation on the use of partial discharge (PD) as a means to study the development of leakage current (LC) on silicone rubber insulators in a salt-fog chamber. Simultaneous measurements of LC and PD on dead-end type silicone rubber insulators exposed to different combinations of electrical stress and salt-fog salinity are performed. The results show that for an electrical stress of 33 V/mm applied to the insulator, the average LC experiences gradual changes and reaches a critical level (around 1 mA) where dry-band arcing is observed after 20 minutes at 2300 /spl mu/S/cm, and after 25 minutes at 1800 /spl mu/S/cm. The corresponding PD levels reach hundreds of pC after 15 minutes at 2300 /spl mu/S/cm, and after 20 minutes at 1800 /spl mu/S/cm. For a salinity corresponding to 1800 /spl mu/S/cm and stress of 26 V/mm, the LC changes much more gradually and reaches the critical level only after approximately 60 minutes. The corresponding PD reaches hundreds of pC after 30 minutes and more than 1500 pC after 60 minutes. Pattern recognition techniques have been applied to investigate the transition from corona to dry-band arcing. The features extracted from the maximum and mean apparent charge trends are found to be useful to cluster and classify the two phenomena. Simultaneous visual observations of the discharges on the insulator surface support the results. The investigation, therefore, shows that PD is a sensitive method for detecting the transition from corona from water droplets to dry-band arcing and an alternative method for studying the early aging stage of silicone rubber insulators.