The paper presents in the first part a diagnosis of the frequency per year of the pull and torque test followed by an analysis of the average time given to each attempt, a comparison of the average time spent on the torqueing and pulling test and the average times to perform the other tests. In the second part there is a forecast of the times spent performing the test following the optimization. The optimization is performed in the first phase at project level in the Inventor Professional 2018 program. The testing method is not foreign to companies that produce cable cord, and is it described in at least two standards. The latest developments in the electronics field show an optimization on two separate devices for each stress, pull and torque. The goal of this paper is to present an optimization of the device for pull stress testing, in order to proceed with both of the stresses on one device. The optimization aims to reduce the time spent by the quality tester in the metrological laboratory on this test. Following the optimization, in the forecast it was found that the quality of work was improved by reducing working hours and removing human assistance as much as possible in order to eliminate the errors caused by it.
展开▼
