首页> 外文期刊>Atmospheric Chemistry and Physics Discussions >Modeling particle nucleation and growth over northern California during the 2010 CARES campaign
【24h】

Modeling particle nucleation and growth over northern California during the 2010 CARES campaign

机译:2010年Cares竞选期间北加州北加州核肉成核和生长

获取原文
           

摘要

Accurate representation of the aerosol lifecycle requires adequate modeling of the particle number concentration and size distribution in addition to their mass, which is often the focus of aerosol modeling studies. This paper compares particle number concentrations and size distributions as predicted by three empirical nucleation parameterizations in the Weather Research and Forecast coupled with chemistry (WRF-Chem) regional model using 20 discrete size bins ranging from 1 nm to 10 μm. Two of the parameterizations are based on H2SO4, while one is based on both H2SO4 and organic vapors. Budget diagnostic terms for transport, dry deposition, emissions, condensational growth, nucleation, and coagulation of aerosol particles have been added to the model and are used to analyze the differences in how the new particle formation parameterizations influence the evolving aerosol size distribution. The simulations are evaluated using measurements collected at surface sites and from a research aircraft during the Carbonaceous Aerosol and Radiative Effects Study (CARES) conducted in the vicinity of Sacramento, California. While all three parameterizations captured the temporal variation of the size distribution during observed nucleation events as well as the spatial variability in aerosol number, all overestimated by up to a factor of 2.5 the total particle number concentration for particle diameters greater than 10 nm. Using the budget diagnostic terms, we demonstrate that the combined H2SO4 and low-volatility organic vapor parameterization leads to a different diurnal variability of new particle formation and growth to larger sizes compared to the parameterizations based on only H2SO4. At the CARES urban ground site, peak nucleation rates are predicted to occur around 12:00 Pacific (local) standard time (PST) for the H2SO4 parameterizations, whereas the highest rates were predicted at 08:00 and 16:00 PST when low-volatility organic gases are included in the parameterization. This can be explained by higher anthropogenic emissions of organic vapors at these times as well as lower boundary-layer heights that reduce vertical mixing. The higher nucleation rates in the H2SO4-organic parameterization at these times were largely offset by losses due to coagulation. Despite the different budget terms for ultrafine particles, the 10–40 nm diameter particle number concentrations from all three parameterizations increased from 10:00 to 14:00 PST and then decreased later in the afternoon, consistent with changes in the observed size and number distribution. We found that newly formed particles could explain up to 20–30 % of predicted cloud condensation nuclei at 0.5 % supersaturation, depending on location and the specific nucleation parameterization. A sensitivity simulation using 12 discrete size bins ranging from 1 nm to 10 μm diameter gave a reasonable estimate of particle number and size distribution compared to the 20 size bin simulation, while reducing the associated computational cost by ~ 36 %.
机译:对于气溶胶生命周期的准确表示,除了质量之外,还需要足够的粒子数浓度和尺寸分布的建模,这通常是气溶胶建模研究的重点。本文将粒子数浓度和尺寸分布与三个经验核心参数化的粒子数浓度和尺寸分布进行了比较,与化学(WRF-Chem)区域模型一起使用的20个离散尺寸箱,从1nm至10μm的范围内耦合。两个参数化基于H2SO4,而其中一个基于H2SO4和有机蒸气。在模型中加入了运输,干沉积,排放,冷凝生长,成核和凝聚和凝聚的预算诊断术语,并用于分析新的粒子形成参数如何影响发展气溶胶尺寸分布的差异。使用在表面位点收集的测量和从研究飞机在碳质气溶胶和加利福尼亚州的附近进行的散热效果研究(Cares)进行评估模拟。虽然所有三个参数化捕获了观察到的成核事件期间尺寸分布的时间变化以及气溶胶数中的空间变异性,全部高估到2.5倍的粒子数浓度大于10nm的总粒子数浓度。使用预算诊断术语,我们证明组合的H2SO4和低挥发性有机蒸气参数化导致与基于H2SO4的参数化相比,新的粒子形成和较大尺寸的不同差值变异性。在Cares Urban接地站点,预计峰值成率率将在H2SO4参数化下到12:00(本地)标准时间(PST)大约发生,而最高速率在08:00和16:00 PST时预测挥发性有机气体包括在参数化中。这可以通过这些时间的有机蒸汽的更高人为排放来解释,以及减少垂直混合的下边界层高度。在这些时间的H 2 SO 4-有机参数化中的较高成核率在很大程度上因凝血而导致的损耗偏移。尽管超细颗粒的预算术语不同,但来自所有三个参数的10-40nm直径粒子数浓度从10:00增加到10:00至14:00,然后在午后后来减少,与观察到的尺寸和数字分布的变化一致。我们发现,新形成的颗粒可以在0.5%的过饱和下解释高达20-30%的预测云凝结核,这取决于位置和特定的成核参数化。使用12个离散尺寸箱的灵敏度仿真范围为1nm至10μm直径,与20尺寸的箱模拟相比,粒子数和尺寸分布的合理估计,同时将相关的计算成本降低〜36%。

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号