首页> 外文期刊>Atmospheric Chemistry and Physics Discussions >Simulating the SOA formation of isoprene from partitioning and aerosol phase reactions in the presence of inorganics
【24h】

Simulating the SOA formation of isoprene from partitioning and aerosol phase reactions in the presence of inorganics

机译:在无机物存在下,模拟异戊二烯的SOA形成和气溶胶相反应

获取原文
           

摘要

The secondary organic aerosol (SOA) produced by the photooxidation of isoprene with and without inorganic seed is simulated using the Unified Partitioning Aerosol Phase Reaction (UNIPAR) model. Recent work has found the SOA formation of isoprene to be sensitive to both aerosol acidity ([H+], mol?L?1) and aerosol liquid water content (LWC) with the presence of either leading to significant aerosol phase organic mass generation and large growth in SOA yields (YSOA). Classical partitioning models alone are insufficient to predict isoprene SOA formation due to the high volatility of photooxidation products and sensitivity of their mass yields to variations in inorganic aerosol composition. UNIPAR utilizes the chemical structures provided by a near-explicit chemical mechanism to estimate the thermodynamic properties of the gas phase products, which are lumped based on their calculated vapor pressure (eight groups) and aerosol phase reactivity (six groups). UNIPAR then determines the SOA formation of each lumping group from both partitioning and aerosol phase reactions (oligomerization, acid-catalyzed reactions and organosulfate formation) assuming a single homogeneously mixed organic–inorganic phase as a function of inorganic composition and VOC?∕?NOx (VOC – volatile organic compound). The model is validated using isoprene photooxidation experiments performed in the dual, outdoor University of Florida Atmospheric PHotochemical Outdoor Reactor (UF APHOR) chambers. UNIPAR is able to predict the experimental SOA formation of isoprene without seed, with H2SO4 seed gradually titrated by ammonia, and with the acidic seed generated by SO2 oxidation. Oligomeric mass is predicted to account for more than 65?% of the total organic mass formed in all cases and over 85?% in the presence of strongly acidic seed. The model is run to determine the sensitivity of YSOA to [H+], LWC and VOC?∕?NOx, and it is determined that the SOA formation of isoprene is most strongly related to [H+] but is dynamically related to all three parameters. For VOC?∕?NOx????10, with increasing NOx both experimental and simulated YSOA increase and are found to be more sensitive to [H+] and LWC. For atmospherically relevant conditions, YSOA is found to be more than 150?% higher in partially titrated acidic seeds (NH4HSO4) than in effloresced inorganics or in isoprene only.
机译:使用统一的分配气溶胶相反应(UniPar)模型模拟​​由异戊二烯的光氧化产生的二次有机气溶胶(SOA)产生的异戊二烯和没有无机种子。最近的工作已发现异戊二烯的SOA形成对气溶胶酸度([H +],摩尔·α1)和气溶胶液体含水量(LWC)的存在敏感,存在导致显着的气溶胶相机有机质量大量和大量SOA产量增长(YSOA)。单独的典型分区模型不足以预测异戊二烯SOA形成,由于光氧化产物的高挥发性和它们的质量产生的敏感性对无机气溶胶组合物的变化。 UniPar利用近乎明确的化学机制提供的化学结构来估计气相产物的热力学性质,基于其计算的蒸气压(8组)和气溶胶相反应性(6组)。 UNIPAR然后确定从两个分区各结块组的SOA形成并假设一个单一均匀混合的有机 - 无机相作为无机组合物和VOC?/?的NOx的功能气雾剂相反应(低聚,酸催化的反应和有机硫酸盐的形成)( VOC - 挥发性有机化合物)。使用异戊二烯光氧化实验进行验证,在佛罗里达州户外大学光化学室外反应器(UF Aphor)腔室中的双重。 UNIPAR能够预测不含种子的异戊二烯的实验SOA形成,H2SO4种子逐渐通过氨逐渐滴定,并用SO2氧化产生的酸性种子。预测寡聚物质以占所有病例中形成的总有机质量的65倍以上,并且在受强酸性的种子存在下超过85℃。运行该模型以确定YSOA至[H +],LWC和VOC的敏感性,并且确定异戊二烯的SOA形成与[H +]最强烈相关,但是与所有三个参数动态相关。对于VOC?/?NOx ???? 10,随着NOx的增加,两种实验和模拟的YSOA增加,发现对[H +]和LWC更敏感。对于大气相关的条件,部分滴定的酸性种子(NH4HSO4)发现ysOA比效氯的无机或异戊二烯更高。

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号