Preliminary 3D printing of large inclined-shaped alumina ceramic parts by direct ink writing

摘要

Three dimensional (3D) printing technology by direct ink writing (DIW) is an innovative complex shaping technology, possessing advantages of flexibility in fabrication, high efficiency, low cost, and environmental-friendliness. Herein, 3D printing of complex alumina ceramic parts via DIW using thermally induced solidification with carrageenan swelling was investigated. The rheological properties of the slurry under different thermally-induced modes were systematically studied. The solidification properties of thermally-induced pastes with varying contents of carrageenan were optimized. The experimental results showed that the optimized paste consisting of 0.4 wt% carrageenan could be rapidly solidified at about 55 °C, which could print inclined-plane more than 60° in vertical without support, resulting in better homogeneity of the green body. A nearly pore-free structure was obtained after sintering at 1600 °C for 2 h.