首页> 外文期刊>ACS Omega >Self-Assemblies of Zinc Complexes for Aggregation-Induced Emission Luminogen Precursors
【24h】

Self-Assemblies of Zinc Complexes for Aggregation-Induced Emission Luminogen Precursors

机译:聚集诱导的发射光荧光前体的锌络合物的自组装

获取原文
获取外文期刊封面目录资料

摘要

Positional isomers of zinc–nitrobenzoate complexes possessing pyridine -3-(or-4-) carboxamide are used for a comparative theoretical and experimental study to understand their utility as model complexes to understand the role of metal-to-ligand charge transfer in aggregation-induced emission (AIE). Among the five different model zinc complexes, four of them are non-ionic, and one is an ionic complex. The frontier molecular energy levels of different combinations of the positional isomeric complexes and the absorption maximum were ascertained by density functional theory calculations. The PolyQ value obtained from solid samples of each complex is different. Shifts in the emissions to higher wavelengths than the expected emission for the S_(1) to S_(0) transition were observed due to aggregations. The highest value of PolyQ among the complexes was 13.56% observed for emission at 439 nm (λ_(ex) = 350) of the non-ionic complex, namely, (di-aqua)bis(pyridine-3-carboxamide)di(2-nitrobenzoato)zinc(II) monohydrate. Close resemblance in emission lifetime decay profiles of the solid samples of those complexes and the respective solutions of those complexes in dimethyl sulfoxide with or without water showed a common trend, suggesting aggregation-induced emission in each case. Aggregation-induced emission caused by adding water in dimethyl sulfoxide solution of each complex showed an initial increase without a shift in the emission wavelength followed by a quenching with a shift of the respective emission peak to a short wavelength. Dynamic light scattering studies showed an increase in the average particle sizes upon an increase in the concentration of water. This indicated initial participation of water molecules to form aggregates with the complexes, favoring an increase in the AIE intensity. Aggregation of each complex changes with the concentration of water, and an increase in the concentration of water beyond a characteristic limit causes lowering of the emission intensity to the short wavelength.
机译:具有吡啶-3-(或-4-)甲酰胺的锌 - 硝基苯甲酸锌络合物的位置异构体用于比较理论和实验研究,以了解他们的效用作为模型复合物,以了解金属与配体电荷转移在聚集中的作用 - 诱导排放(AIE)。在五种不同的模型锌络合物中,其中四个是非离子的,并且一种是离子复合物。通过密度函数理论计算确定了位置异构络合物的不同组合的前部分子能量和吸收最大值。从每个复合物的固体样品获得的多议值不同。由于聚合,观察到比在S_(1)到S_(0)转换的更高波长的排放到更高波长的变化。在非离子复合物的439nm(λ_(ex)= 350)的发射中,络合物中Polyq的最高值为13.56%,即(Di-Aqua)双(吡啶-3-甲酰酰胺)DI(2 - 硝基苯乙烯)锌(II)一水合物。在这些复合物的固体样品的排放寿命衰减型材中紧密相似,并且在具有或不含水的二甲基亚甲醚中的这些配合物的各自溶液的各自溶液显示出共同的趋势,表明每种情况下的聚集诱导的发射。通过在每个复合物的二甲基亚砜溶液中加入水的聚集诱导的发射显示初始增加,而没有在发射波长的偏移,然后淬灭,然后将各个发射峰的偏移到短波长。动态光散射研究表明,在水浓度的增加时,平均粒径增加。这表明水分子与复合物形成聚集体的初始参与,有利于AIE强度的增加。每种复杂变化的聚集随着水的浓度,并且超出特征极限的水浓度的增加导致降低发光强度到短波长。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号