...
首页> 外文期刊>Journal of Mining and Metallurgy, Section B: Metallurgy >The influence of Si and V on the kinetics of phase transformation and microstructure of rapidly solidified Al-Fe-Zr alloys
【24h】

The influence of Si and V on the kinetics of phase transformation and microstructure of rapidly solidified Al-Fe-Zr alloys

机译:硅和钒对快速凝固Al-Fe-Zr合金相变动力学和组织的影响

获取原文
           

摘要

The influence of Si and V on the precipitation kinetics of the rapidly solidified (RS) Al-Fe-Zr alloys is presented. Precipitation kinetics and microstructural development of RS Al-Fe-Zr alloys with Si or V addition have been investigated by the combination of four point electrical resistance measurement, optical microscopy, transmition electron microscopy (TEM) and scanning electron microscopy (SEM). For verification of the electrical resistivity measurement results differential scanning calorimetry (DSC) and differential thermal analysis (DTA) was also applied. Rapidly solidified samples, in the form of thin ribbons, were prepared with the single roll melt spun technique. For determination of the distinctive temperatures at which microstructural transformations occur in-situ electrical resistivity measurement during heating of the ribbons with various constant heating rates has been used. It was found that microstructure decomposition depends on heating rate and shifts to higher temperatures with increasing heating rate. After heating above the distinctive transition temperatures, heating was stopped and microstructure of the samples examined by electron microscopy.
机译:提出了硅和钒对快速凝固(RS)Al-Fe-Zr合金析出动力学的影响。通过四点电阻测量,光学显微镜,透射电子显微镜(TEM)和扫描电子显微镜(SEM)的组合,研究了添加Si或V的RS Al-Fe-Zr合金的沉淀动力学和微观组织发展。为了验证电阻率测量结果,还使用了差示扫描量热法(DSC)和差示热分析(DTA)。用单辊熔纺技术制备呈薄带状的快速固化样品。为了确定在不同的恒定加热速率下加热带的过程中发生微结构转变的独特温度,电阻率测量被使用。已经发现,微结构分解取决于加热速率,并且随着加热速率的增加而转变成更高的温度。在加热到独特的转变温度以上之后,停止加热,并通过电子显微镜检查样品的微观结构。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号