Hemiepiphysiodesis using tension band plates: does the initial screw angle influence the rate of correction?

摘要

Purpose When using tension band plates for angular deformity correction, the literature is unclear regarding the most effective screw insertion angle to use. This study evaluates the correlation between initial screw angle and the average rate of correction during hemiepiphysiodesis using tension band plates Methods This retrospective study includes 35 patients (47 physes) with genu valgum deformity (17 idiopathic and 18 fibular hemimelia) who underwent insertion of Eight-Plates between 2010 and 2015. Initial screw angle was determined from the intraoperative fluoroscopic images. Radiographs were obtained within three months of surgery, and follow-up films were obtained every three to six months. Change in mechanical lateral distal femoral angle, medial proximal tibial angle and screw angle was obtained from each follow-up radiograph. Initial screw angle was correlated with the average rate of correction during the entire treatment period. The average rate of angular correction during first and last follow-up periods was also compared. Results The relationship between the initial screw angle and the mean rate of angular correction was not statistically significant (p = 0.2). The rate of angular correction during the first follow-up period (mean of 4.7 months) was 0.86° per month compared with 0.71° per month during the last follow-up period (mean of 5.1 months). Conclusion Application of a tension band plate with a divergence angle ranging from 0° to 30° results in similar rates of angular correction. For surgeons inserting screw-plate tension band devices, there does not seem to be any necessity to make the screws parallel or divergent. We recommend that screw placement be anatomically correct, i.e. not impinging on the physis, rather than favouring any particular divergence angle. Level of evidence IV