首页> 外文期刊>Journal of Chemical Engineering of Japan >Desulfurization Ability of Metallurgical Dusts from Blast Furnace Ironmaking Process
【24h】

Desulfurization Ability of Metallurgical Dusts from Blast Furnace Ironmaking Process

机译:高炉炼铁过程中冶金粉尘的脱硫能力

获取原文
           

摘要

References(10) Cited-By(3) The sulfur capacity of metallurgical dusts from blast furnace ironmaking processes was measured in the temperature range from 298 to 923 K. The experimental results show that the sulfur capacity of metallurgical dusts is considerably increased with the increase of temperature from 298 to 923 K. The desulfurization ability of metallurgical dusts is mainly depend on its content of oxides of ZnO, PbO, CaO and MnO when the temperature is lower than 623 K, but when the temperature is higher than 623 K the contributions of iron oxides become dominant. Carbon content, due to its absorption effect, has a positive effect on the desulfurization ability of metallurgical dusts below 623 K. If the temperature increased to higher than 623 K the absorption effect of carbon disappears and the role of desulfurization reaction between H2S and the metal oxide such as ZnO, PbO, Fe2O3, CaO and MnO as well as the H2S diffusion in intraparticle of metallurgical dusts seems more important.
机译:参考文献(10)引用(3)在298至923 K的温度范围内测量了高炉炼铁过程中产生的冶金粉尘的硫容量。实验结果表明,随着粉尘浓度的增加,冶金粉尘的硫容量显着增加。温度从298 K升高到923K。冶金粉尘的脱硫能力主要取决于温度低于623 K时其ZnO,PbO,CaO和MnO的氧化物含量,而当温度高于623 K时,其脱硫能力的氧化铁占主导地位。碳含量由于其吸收作用而对623 K以下的冶金粉尘的脱硫能力产生积极影响。如果温度升高到623 K以上,则碳的吸收作用消失,H2S与金属之间的脱硫反应也将起作用诸如ZnO,PbO,Fe2O3,CaO和MnO之类的氧化物以及H2S在冶金粉尘颗粒内的扩散似乎更为重要。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号