3D Circular Interpolation Motion Equivalent to Cone-Frustum Cutting in Five-Axis Machining Centers and its Sensitivity Analysis

摘要

The present paper describes a testing method for five-axis machining centers using three-dimensional circular interpolation movement equivalent to cone-frustum cutting. In the present paper, the test conditions, such as the half apex angle of cone-frustum and the sensitive directions of the ball bar device were investigated. In addition, the sensitivity coefficient of each axis was investigated. It is found from the analysis of the sensitivity coefficient that the trajectory due to the errors of the axis of rotation is strongly affected by the sensitive direction of the ball bar for the case of a half apex angle of 45°.