首页> 外文期刊>Petroleum science >Pore-scale investigation of residual oil displacement in surfactant–polymer flooding using nuclear magnetic resonance experiments
【24h】

Pore-scale investigation of residual oil displacement in surfactant–polymer flooding using nuclear magnetic resonance experiments

机译:利用核磁共振实验对表面活性剂-聚合物驱中残余油驱替进行孔隙度研究

获取原文
           

摘要

Research on the Gangxi III area in the Dagang Oilfield shows that there was still a significant amount of oil remaining in oil reservoirs after many years of polymer flooding. This is a potential target for enhanced oil recovery (EOR). Surfactant–polymer (SP) flooding is an effective chemical EOR method for mobilizing residual oil and improving displacement efficiency macroscopically, but the microscopic oil displacement efficiency in pores of different sizes is unclear. Nuclear magnetic resonance (NMR) is an efficient method for quantifying oil saturation in the rock matrix and analyzing pore structures. In this paper, the threshold values of different pore sizes were established from the relationship between mercury injection curves and NMR T _(2) spectrums. The distribution and migration of residual oil in different flooding processes was evaluated by quantitatively analyzing the change of the relaxation time. The oil displaced from pores of different sizes after the water flood, polymer flood, and the SP flood was calculated, respectively. Experimental results indicate that (1) the residual oil in medium pores contributed the most to the incremental oil recovery for the SP flood, ranging from 40?% to 49?%, and small pores usually contributed <30?%; (2) the residual oil after the SP flood was mainly distributed in small and medium pores; the residual oil in medium pores accounted for 47.3?%–54.7?%, while that trapped in small pores was 25.7?%–42.5?%. The residual oil in small and medium pores was the main target for EOR after the SP flood in oilfields.
机译:对大港油田江西三区的研究表明,经过多年的聚合物驱,油藏中仍然有大量的剩余油。这是提高采油率(EOR)的潜在目标。表面活性剂-聚合物(SP)驱油是一种有效的化学EOR方法,可以从宏观上动员残余油并提高驱油效率,但微观尺寸不同孔隙中的驱油效率尚不清楚。核磁共振(NMR)是一种量化岩石基质中油饱和度并分析孔隙结构的有效方法。本文通过水银注入曲线与NMR T _(2)光谱之间的关系确定了不同孔径的阈值。通过定量分析松弛时间的变化,评价了剩余油在不同驱油过程中的分布和运移。分别计算了水驱,聚合物驱和SP驱后从不同尺寸的孔隙中驱出的油。实验结果表明:(1)中孔中的残余油对SP驱油增量采收率的贡献最大,范围从40%到49%,小孔通常小于30%。 (2)SP驱后的残留油主要分布在中,小孔中。中孔残留油占47.3%-54.7%,小孔残留油占25.7%-42.5%。油田SP驱后,小孔和中孔的残余油是提高采收率的主要目标。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号