MODEL TEST AND CONSOLIDATION ANALYSIS OF FAILURE OF A LOOSE SANDY EMBANKMENT DAM DURING SEEPAGE

摘要

References(23) Cited-By(1) Failures of earth dam embankments and river dikes, which are constructed of sandy soils with low dry densities, have been observed to occur during rising of water levels. In this paper, a large-scale physical model test was conducted in order to investigate the behavior of a small dam embankment as water levels rose. The test results were simulated by use of a consolidation analysis method coupled with an elastoplastic model for unsaturated soils. All parameters used in the simulation were obtained from element tests; oedometer, triaxial compression, soil water retention, and permeability tests. First, in order to verify the parameters identified, direct shear tests were simulated using the consolidation analysis method; results of the simulation and the tests were consistent. From the embankment model test it was found that the crest of the embankment moved upstream at the first stage of impounding and then moved back. After a seepage surface appeared on the downstream slope, tension cracks occurred on the downstream slope, and sliding occurred through the crack and the downstream toe. The results of the simulation were consistent with those of the model test. This consolidation analysis method could be used to simulate the complex deformations induced by saturation collapse and shear strains and even failure behavior. Old embankments constructed with loose densities might have histories in which cracks occurred on the downstream slopes when the reservoir water level rose, and their stabilities might have decreased.